Left vehicle controller alerts

VCLEFT alert codes

Showing 101–150 of 393

• VCLEFT_a155 — Autopilot Drive Not Authed VCLEFT_a155_autopilotDriveNotAuthed Autopilot has requested DRIVE power state without a key being present.
• VCLEFT_a163 — Stc Trip VCLEFT_a163_stcTrip The Switched Tank Converter is in a faulted condition.
• VCLEFT_a164 — Ungraceful Acc Plus Exit VCLEFT_a164_ungracefulAccPlusExit A sudden transition out of Accessory Plus state was requested, where entertainment and media may have been actively used while in Park (including Arcade Mode or Theater Mode). Drive will be unavailable for 10 seconds while the vehicle tran…
• VCLEFT_a165 — Drive Blckd By Showroom VCLEFT_a165_driveBlckdByShowroom The vehicle is unable to drive because it has been placed in Showroom Mode, a mode intended for display rather than driving. This should not occur with a production vehicle once it has been delivered. If this occurs due to an error, servic…
• VCLEFT_a166 — EGGLEFT MIA VCLEFT_a166_EGGLEFT_MIA One or more of the expected CAN messages from the Etherloop Generalized Gateway Left (Core 0) were not received, indicating the EGGLEFT ECU may be unavailable (MIA).
• VCLEFT_a167 — Left HCMMIA VCLEFT_a167_leftHCMMIA One or more of the messages the vehicle controller receives periodically from the left headlamp controller is not received, indicating the left headlamp controller may be unavailable (MIA).
• VCLEFT_a168 — VCDOORRL MIA VCLEFT_a168_VCDOORRL_MIA One or more of the messages the vehicle controller receives periodically from the rear left door controller (VCDOORRL) is not received, indicating the VCDOORRL may be unavailable (MIA).
• VCLEFT_a169 — Replace LV Battery2 VCLEFT_a169_replaceLVBattery2 The Low Voltage (LV) battery needs to be replaced. This alert is intended to capture LV battery conditions and assist with diagnosis if primary alert replaceLVBattery cannot be logged by the vehicle Gateway (GTW) at time of initial occurre…
• VCLEFT_a170 — 12v Ov VCLEFT_a170_12vOv The battery voltage measurement, nominally 12 volts, was higher than expected.
• VCLEFT_a171 — 12v Uv VCLEFT_a171_12vUv The battery voltage measurement, nominally 12 volts, was lower than expected.
• VCLEFT_a172 — SPI MIA VCLEFT_a172_SPI_MIA The communication link between Electronic Parking Brake (EPB) and Electronic Parking Brake Monitor (EPBM) is not functioning as expected.
• VCLEFT_a173 — Hi Current Missing VCLEFT_a173_hiCurrentMissing Deprecated, no longer set. An apply/release command was issued to the Electronic Parking Brake while the high current feed was missing
• VCLEFT_a174 — Csm Release Failed VCLEFT_a174_csmReleaseFailed Electronic Parking Brake was unable to release due to fault.
• VCLEFT_a175 — Csm Release Retry VCLEFT_a175_csmReleaseRetry Electronic Parking Brake release was interrupted. Release will be retried.
• VCLEFT_a176 — Csm Apply Failed VCLEFT_a176_csmApplyFailed Electronic Parking Brake apply failed.
• VCLEFT_a177 — Csm Apply Retry VCLEFT_a177_csmApplyRetry Electronic Parking Brake apply was interrupted. Apply will be retried.
• VCLEFT_a178 — Caliper State Unknown VCLEFT_a178_caliperStateUnknown Electronic Parking Brake was not able to determine caliper state on boot.
• VCLEFT_a179 — Epb Problem VCLEFT_a179_epbProblem Customer facing alert for Electronic Parking Brake issues which occur when caliper is not moving
• VCLEFT_a180 — Dynamic Active VCLEFT_a180_dynamicActive Customer facing alert issued when Electronic Parking Brake is applied at higher than 5mph
• VCLEFT_a181 — Too Steep Grade To Park VCLEFT_a181_TooSteepGradeToPark Road grade is too steep to secure with Park Brake
• VCLEFT_a182 — One EPB Applied Unsec Env VCLEFT_a182_OneEPBAppliedUnsecEnv One Electronic Parking Brake (EPB) not applied, and road grade is too steep to secure vehicle with only one EPB
• VCLEFT_a183 — Cdp Not Available VCLEFT_a183_cdpNotAvailable Stability Control reports Controlled Deceleration for Parking Brake is not available when car is in DRIVE
• VCLEFT_a184 — Dynamic Park Abort VCLEFT_a184_dynamicParkAbort Non-nominal termination of dynamic park
• VCLEFT_a185 — Summon Aborted VCLEFT_a185_summonAborted
• VCLEFT_a186 — External Park Abort VCLEFT_a186_externalParkAbort Non-nominal termination of external park
• VCLEFT_a187 — Cdp Dynamic VCLEFT_a187_cdpDynamic Stability Control has begun Controlled Deceleration for Parking Brake
• VCLEFT_a188 — Epb Dynamic VCLEFT_a188_epbDynamic Electronic Parking Brake is performing dynamic apply
• VCLEFT_a189 — Epb Dynamic Park Canceled VCLEFT_a189_epbDynamicParkCanceled Electronic Parking Brake was attempting to dynamic park, Controlled Deceleration for Parking Brake is unavailable, and speed crossed above 8.8kph
• VCLEFT_a190 — Csm Apply Degraded VCLEFT_a190_csmApplyDegraded Electronic Parking Brake apply failed.
• VCLEFT_a191 — Csm Release Degraded VCLEFT_a191_csmReleaseDegraded Electronic Parking Brake was unable to release fully.
• VCLEFT_a192 — Rad Fan General Fault VCLEFT_a192_radFanGeneralFault The radiator fan brushless motor controller reports a condition affecting its operation.
• VCLEFT_a193 — Rad Fan MIA VCLEFT_a193_radFanMIA Radiator Fan Controller not responding on LIN
• VCLEFT_a194 — DCDC Not Supporting LV Bus VCLEFT_a194_DCDCNotSupportingLVBus The low voltage (LV) bus and LV battery are not adequately supported by the power conversion system (PCS).
• VCLEFT_a195 — Park For Driver Is Leaving VCLEFT_a195_parkForDriverIsLeaving The Electronic Parking Brake (EPB) reports the driver is leaving and parks the vehicle.
• VCLEFT_a196 — Free Roll Mode Active VCLEFT_a196_freeRollModeActive will prevent EPB from parking when the driver leaves
• VCLEFT_a197 — Free Roll Mode At Speed VCLEFT_a197_freeRollModeAtSpeed If vehicle reaches 8.8kph, EPB will park
• VCLEFT_a198 — Hold Clamp Complete VCLEFT_a198_holdClampComplete EPB hold clamp finished, log I, V, and calculated R
• VCLEFT_a199 — Discnctd LV Battery VCLEFT_a199_discnctdLVBattery The low voltage (LV) battery is disconnected.
• VCLEFT_a200 — Pm Unpark Not Allowed VCLEFT_a200_PmUnparkNotAllowed DI requested unpark but PM didn't allow it
• VCLEFT_a201 — Precharge Failed VCLEFT_a201_prechargeFailed The Left Vehicle Controller (VCLEFT) precharge circuit did not raise the voltage to the target voltage in the expected amount of time.
• VCLEFT_a202 — Remote Epb Config Incompatible VCLEFT_a202_remoteEpbConfigIncompatible EPB's brake HW config is not compatible remote EPB's brake HW config
• VCLEFT_a203 — Hw Brake Type Mismatch VCLEFT_a203_hwBrakeTypeMismatch Electronic Parking Brake's learned configuration does not match the reported config from the gateway
• VCLEFT_a204 — Undervoltage Loadshed Triggered VCLEFT_a204_undervoltageLoadshedTriggered Undervoltage loadshed protection has tripped on the Left Vehicle Controller (VCLEFT). Low Voltage (LV) bridge is expected to be open until the protection is cleared.
• VCLEFT_a205 — Overvoltage Shutdown Triggered VCLEFT_a205_overvoltageShutdownTriggered Overvoltage protection has tripped on the Left Vehicle Controller (VCLEFT). Low Voltage (LV) bridge is expected to be open until the protection is cleared.
• VCLEFT_a206 — Max Chrge Sssion Tmeout VCLEFT_a206_maxChrgeSssionTmeout The low voltage (LV) battery charge cycle was stopped before it reached either its Amp hour or current targets, as the maximum time period for a charging session timeout had been reached.
• VCLEFT_a207 — Exit Drive Low LV Bus Voltage VCLEFT_a207_exitDriveLowLVBusVoltage An issue with the low voltage (LV) electrical system requires the vehicle to come to a stop immediately. The vehicle should enter graceful power-off (GPO) to exit drive, and a separate alert should indicate that condition.
• VCLEFT_a208 — Replace LV Battery VCLEFT_a208_replaceLVBattery The Low Voltage (LV) battery needs to be replaced.
• VCLEFT_a209 — IBSMIA VCLEFT_a209_IBSMIA One or more of the serial peripheral interface (SPI) messages the vehicle controller receives periodically from the Intelligent Battery Sensor (IBS) is not received, indicating the IBS may be unavailable (MIA).
• VCLEFT_a210 — Park For Driver Is Leaving Debug VCLEFT_a210_parkForDriverIsLeavingDebug The Electronic Parking Brake (EPB) reports the driver is leaving and parks the vehicle.
• VCLEFT_a211 — Can Rx Fifo Overrun VCLEFT_a211_canRxFifoOverrun Software failed to process incoming CAN messages fast enough and a message was lost