Left vehicle controller alerts

VCLEFT alert codes

Showing 151–200 of 393

• VCLEFT_a212 — IBS Over Temp VCLEFT_a212_IBSOverTemp The intelligent battery sensor (IBS) is reporting a temperature value over 80 degrees C.
• VCLEFT_a213 — LV Overcharge VCLEFT_a213_LVOvercharge Over multiple discharge and recharge cycles, the low voltage (LV) battery has been overcharged by more than 5 Amp hours (Ah) compared to initial charge level. Indicates a condition affecting LV battery performance that makes replacement ne…
• VCLEFT_a214 — Bridge Open Circuit Detect VCLEFT_a214_bridgeOpenCircuitDetect Current was not seen flowing through the bridge
• VCLEFT_a215 — Vehicle In Self Test VCLEFT_a215_vehicleInSelfTest The vehicle is in a self-test state, which typically indicates a self-test of a vehicle component, system, or functionality is running. Some functions will be inhibited, and some non-standard behaviors will occur.
• VCLEFT_a216 — SPI MIA debug Data1 VCLEFT_a216_SPI_MIA_debugData1 The communication link between Electronic Parking Brake and Electronic Parking Brake Monitor has encountered an error.
• VCLEFT_a217 — SPI MIA debug Data2 VCLEFT_a217_SPI_MIA_debugData2 The communication link between Electronic Parking Brake and Electronic Parking Brake Monitor has encountered an error.
• VCLEFT_a218 — Drve Blckd Vltge Too Hgh VCLEFT_a218_drveBlckdVltgeTooHgh The vehicle cannot enter Drive state because the measured low voltage (LV) battery voltage is too high.
• VCLEFT_a219 — LV Volt Floor Rchd VCLEFT_a219_LVVoltFloorRchd The low voltage (LV) battery has reached its voltage floor before it has reached its Amp hour (Ah) budget. May indicate the LV battery has low charge capacity.
• VCLEFT_a220 — LV Unhealthy VCLEFT_a220_LVUnhealthy The LV system power or protection are compromised, driving is not recommended
• VCLEFT_a221 — Reverse Battery Fault VCLEFT_a221_reverseBatteryFault The reverse battery protection transistor is not in its nominal state / functioning as expected. This occurs when an abnormally high amount of current is detected flowing from the low voltage (LV) battery vehicle controller to the LV batte…
• VCLEFT_a222 — Uv Reference Of Bounds VCLEFT_a222_uvReferenceOfBounds UV protection reference setpoint is unexpected
• VCLEFT_a223 — Bmb eFuse Soft Short Detection VCLEFT_a223_bmbEFuseSoftShortDetection The left domain detects a soft short on the right domain.
• VCLEFT_a224 — Bridge OV Self Test Failure VCLEFT_a224_bridgeOVSelfTestFailure The Bridge Overvoltage self-test did not pass.
• VCLEFT_a225 — Epb Active Decel VCLEFT_a225_epbActiveDecel Stability Control has begun Controlled Deceleration for Parking Brake
• VCLEFT_a226 — Buses Not Sleeping VCLEFT_a226_busesNotSleeping The vehicle cannot enter sleep state due to some electronic control units (ECUs) not going quiet on one or more of the Controller Area Network (CAN) buses.
• VCLEFT_a227 — UI Wakeup Trigger VCLEFT_a227_UIWakeupTrigger The front controller was not able to go to sleep because a UI keep awake reason was triggered.
• VCLEFT_a228 — Sleep Failed VCLEFT_a228_sleepFailed The vehicle controller was not able to go to sleep.
• VCLEFT_a229 — No Drive Chg Cable Con VCLEFT_a229_noDriveChgCableCon Drive has been requested while a charge cable is connected to the vehicle. The vehicle cannot enter drive until the charge cable has been disconnected.
• VCLEFT_a230 — Drive Not Authed VCLEFT_a230_driveNotAuthed Drive has been requested without key authentication.
• VCLEFT_a231 — ADSP MIA VCLEFT_a231_ADSP_MIA One or more expected Controller Area Network (CAN) messages from the Audio Digital Signal Processor (ADSP) electronic control unit (ECU) was not received. ADSP data from accelerometers may be unavailable.
• VCLEFT_a232 — Offroad Mode Persisting Drive VCLEFT_a232_offroadModePersistingDrive Drive was not exited due to being in Offroad Mode
• VCLEFT_a236 — Lumbar Over Pres A VCLEFT_a236_lumbarOverPresA The bladder A has exceeded pressure limits
• VCLEFT_a237 — Lumbar Over Pres B VCLEFT_a237_lumbarOverPresB The bladder B has exceeded pressure limits
• VCLEFT_a238 — Lumbar Valve MIA VCLEFT_a238_lumbarValveMIA The valveblock isn't inflating or deflating when commanded
• VCLEFT_a239 — Nxppca9539 Fault VCLEFT_a239_nxppca9539Fault Unexpected fault in a PCA9539 chip
• VCLEFT_a240 — Controller Wakeup VCLEFT_a240_controllerWakeup Data capture event on front controller wakeup.
• VCLEFT_a241 — Di Output Locked VCLEFT_a241_diOutputLocked A request to change the DI power state has been denied.
• VCLEFT_a242 — Hv Output Locked VCLEFT_a242_hvOutputLocked A request to change the HVC or Contactor power state has been denied.
• VCLEFT_a243 — Bdw Unavailable VCLEFT_a243_bdwUnavailable Brake Disc Wipe algorithm is not running due to loss of input signal(s)
• VCLEFT_a244 — Winch Mode Active VCLEFT_a244_WinchModeActive Non user facing alert set for service set when winch mode is active
• VCLEFT_a245 — Service Mode Active VCLEFT_a245_serviceModeActive User facing to warn that Electronic Parking Brake is in service mode and many Electronic Parking Brake features are disabled
• VCLEFT_a246 — Idle Fault Apply VCLEFT_a246_idleFaultApply Electronic Parking Brake apply failed due to idle fault
• VCLEFT_a247 — Csm Dynamic Apply Retry VCLEFT_a247_csmDynamicApplyRetry Electronic Parking Brake apply was interrupted during dynamic apply. Apply will be retried.
• VCLEFT_a248 — Csm Dynamic Apply Failed VCLEFT_a248_csmDynamicApplyFailed Electronic Parking Brake apply was interrupted during dynamic apply. Apply failed.
• VCLEFT_a249 — Idle Fault Release VCLEFT_a249_idleFaultRelease Electronic Parking Brake release failed due to idle fault
• VCLEFT_a250 — Winch Mode Canceled VCLEFT_a250_WinchModeCanceled Electronic Parking Brake has detected a vehicle speed condition that caused it to exit winch mode.
• VCLEFT_a251 — Current Variance High VCLEFT_a251_currentVarianceHigh Electronic Parking Brake noticed very noisy current
• VCLEFT_a252 — Winch Mode Pending VCLEFT_a252_winchModePending Electronic Parking Brake is preparing to enter winch mode
• VCLEFT_a253 — Esm Release Blocked VCLEFT_a253_esmReleaseBlocked Electronic Parking Brake is preventing calipers from opening
• VCLEFT_a254 — Show Stalk Park Button Fault On Ui VCLEFT_a254_showStalkParkButtonFaultOnUi Electronic Parking Brake has determined that the drive stalk park button has faulted and UI alert should be set allowing driver to park through UI
• VCLEFT_a255 — LV Overcharge Instc VCLEFT_a255_LVOverchargeInstc After a single discharge and recharge cycle, the low voltage (LV) battery has been overcharged by more than 5 Amp hours (Ah) compared to initial charge level. If this continues, it may indicate a condition affecting LV battery performance…
• VCLEFT_a256 — Epb System Apply VCLEFT_a256_epbSystemApply EPB parked the vehicle for a system reason
• VCLEFT_a257 — Left Headlamp Not Aimed VCLEFT_a257_leftHeadlampNotAimed The vehicle controller detects that the left headlight has not been aimed or requires re-aiming.
• VCLEFT_a258 — Resistance Estimation Run VCLEFT_a258_resistanceEstimationRun The test to capture the load current, battery temperature, voltage dip, pass/fail criteria.
• VCLEFT_a259 — LV Voltage Drop On High Load Current VCLEFT_a259_LVVoltageDropOnHighLoadCurrent The vehicle controller detects the low voltage (LV) battery voltage is lower than expected during a precharge event. When this occurs too many times, separate alerts will also be present to indicate precharging the high voltage (HV) bus ma…
• VCLEFT_a260 — Dead LV Battery VCLEFT_a260_deadLVBattery The vehicle controller detects the the low voltage (LV) battery may be overdischarged and no longer functional. This may indicate the LV battery has been damaged due to deep discharge, or it may indicate the LV battery voltage has dropped…
• VCLEFT_a261 — Winch Mode Without Steering VCLEFT_a261_winchModeWithoutSteering The Electronic Parking Brake (EPB) enabled Winch Mode but did not receive the expected messages from the steering system.
• VCLEFT_a262 — Cannot Prepare Winch Mode VCLEFT_a262_cannotPrepareWinchMode Non user facing alert set when user attempts to enter winch mode but a system reason prevents EPB from activating winch mode
• VCLEFT_a263 — Epb Recovery Park VCLEFT_a263_epbRecoveryPark The Electronic Parking Brake (EPB) attempted to park to establish vehicle security for Low Voltage system recovery.
• VCLEFT_a264 — Winch Mode Deactivated VCLEFT_a264_winchModeDeactivated Non user facing alert set when winch mode deactivates