Left vehicle controller alerts

VCLEFT alert codes

Showing 201–250 of 393

• VCLEFT_a265 — Can Rx Checksum Error VCLEFT_a265_canRxChecksumError Software detected a checksum error
• VCLEFT_a271 — Headlamp Retry Info VCLEFT_a271_headlampRetryInfo Periodic information regarding the status of a headlamp retry channel (i.e., number of retries that have occured, current retry state, etc.).
• VCLEFT_a272 — Vhcl Pwr State Msmtch VCLEFT_a272_vhclPwrStateMsmtch Vehicle attempted a power state transition which the Electronic Parking Brake did not agree with.
• VCLEFT_a273 — Wiper Friction Model Fault VCLEFT_a273_wiperFrictionModelFault Inwipe/outwipe friction power estimates have been reported as invalid for the past three wipes.
• VCLEFT_a275 — T LVBMS Bmb Communication VCLEFT_a275_TLVBMS_BmbCommunication A communication interruption has been detected in the Battery Monitoring Board (BMB) chain
• VCLEFT_a276 — T LVBMS Bmb Data Integrity Loss VCLEFT_a276_TLVBMS_BmbDataIntegrityLoss Data integrity loss due to Battery Monitoring Board (BMB) chain double break
• VCLEFT_a277 — T LVBMS Bmb Status Reg Error VCLEFT_a277_TLVBMS_BmbStatusRegError A Battery Monitoring Board (BMB) device status register error indication has been detected
• VCLEFT_a278 — T LVBMS Bmb Hw Over Current Fault VCLEFT_a278_TLVBMS_BmbHwOverCurrentFault A Battery Monitoring Board (BMB) device detects a Hardware (HW) over current condition.
• VCLEFT_a285 — Seat Heat Over Curr Front VCLEFT_a285_seatHeatOverCurrFront The seat heater has had unusually high current draw.
• VCLEFT_a286 — Seat Heat HSD Error Front VCLEFT_a286_seatHeatHSDErrorFront The high side driver (HSD) for the front seat heater has detected an error condition, which may lead to the seat heater not performing as designed.
• VCLEFT_a287 — Seat Heat Disabled F VCLEFT_a287_seatHeatDisabledF The front seat heater is not heating as expected.
• VCLEFT_a293 — Frunk Emergency Release Switch Fault VCLEFT_a293_frunkEmergencyReleaseSwitchFault The vehicle controller detects a condition affecting the frunk emergency release switch.
• VCLEFT_a295 — Seat Below Min Pump Tmp VCLEFT_a295_seatBelowMinPumpTmp The cabin temperature is below the minimum pump temperature
• VCLEFT_a296 — Steering Wheel Heater Compromised VCLEFT_a296_steeringWheelHeaterCompromised The steering wheel heater controller has detected a condition affecting the steering wheel heater mat.
• VCLEFT_a297 — T LVBMS Bmb Hw Over Temperature Fault VCLEFT_a297_TLVBMS_BmbHwOverTemperatureFault A Battery Monitoring Board (BMB) device has detected an over temperature condition
• VCLEFT_a298 — Sws MIA VCLEFT_a298_swsMIA Steering Wheel Controller not responding on LIN
• VCLEFT_a299 — Wipers Factory Disabled VCLEFT_a299_wipersFactoryDisabled The wipers have been disabled while the vehicle is in Factory Mode. The wiper enable routine must be run to restore wiper function.
• VCLEFT_a300 — Left Right Confusion VCLEFT_a300_leftRightConfusion Electronic Parking Brake not sure if it is a left or a right.
• VCLEFT_a301 — Ooc Speed Violation VCLEFT_a301_oocSpeedViolation Vehicle speed is limited based on ultrasonic distance measurements. Currently in ghosted alert.
• VCLEFT_a302 — Csm Long Release VCLEFT_a302_csmLongRelease EPB releases no-load is measured using derivative of current. Currently in ghosted alert.
• VCLEFT_a303 — Clamping Occured Early VCLEFT_a303_clampingOccuredEarly When EPB was applying the current measured went above the max no load current before piston position estimate predicted it would.
• VCLEFT_a304 — Wiper Comm Error VCLEFT_a304_wiperCommError The left vehicle controller detects a wiper module communication error, indicating the wiper module may be disconnected.
• VCLEFT_a338 — Drive Blckd By Msmtch VCLEFT_a338_driveBlckdByMsmtch The vehicle has detected at least one electronic control unit (ECU) running a firmware (software) version that may not be compatible with the firmware installed on the rest of the vehicle. When this occurs, the vehicle controller blocks dr…
• VCLEFT_a339 — Wste Ht Blckd By Msmtch VCLEFT_a339_wsteHtBlckdByMsmtch The vehicle has detected at least one electronic control unit (ECU) required to supplement high voltage (HV) battery heating with waste heat running a firmware (software) version that may not be compatible with the firmware installed on th…
• VCLEFT_a340 — HV Blckd By Msmtch VCLEFT_a340_HVBlckdByMsmtch The vehicle has detected at least one electronic control unit (ECU) required for high voltage (HV) system operation running a firmware (software) version that may not be compatible with the firmware installed on the rest of the vehicle. Wh…
• VCLEFT_a350 — Ens Out Of Range VCLEFT_a350_ensOutOfRange The Emergency Notification Signal (ENS) harness may be disconnected or the Restraints Control Module (RCM) may be missing (MIA).
• VCLEFT_a353 — Missing Speed Unable To Park VCLEFT_a353_missingSpeedUnableToPark EPB speed class is currently UNKNOWN and is not parked.
• VCLEFT_a354 — Parked For Low Brake Fluid Mode VCLEFT_a354_parkedForLowBrakeFluidMode Vehicle was in factory mode with low brake fluid and brake pedal was pressed causing EPB to park.
• VCLEFT_a355 — Brake Hw And Epb Hw Mismatch VCLEFT_a355_brakeHwAndEpbHwMismatch EPB calculate brake hw config and epb hw config independently and checks they are the same
• VCLEFT_a356 — Parking For Stationary Detect VCLEFT_a356_parkingForStationaryDetect Startionary detect can park vehicle if all speed sources are MIA and algo detects no motion.
• VCLEFT_a357 — Brakes Too Hot For Slope VCLEFT_a357_brakesTooHotForSlope Brake temperature is above 200C and slope is greater than 10%
• VCLEFT_a358 — Brakes Too Hot For Slope With Only One Epb VCLEFT_a358_brakesTooHotForSlopeWithOnlyOneEpb Brake temperature is above 200C and slope is greater than 5%
• VCLEFT_a359 — Post POR Excessive Ah VCLEFT_a359_postPORExcessiveAh After a vehicle power-on-reset (POR), the vehicle controller detects the low voltage (LV) battery has consumed too many Amp hours (Ah) during its initial charge, indicating the LV battery was deeply discharged prior to the power-on-reset.
• VCLEFT_a360 — Ibst Brake Switch Invalid VCLEFT_a360_ibstBrakeSwitchInvalid EPB defaults to using IBST for brake switch detection but will fallback to ESP if IBST invalid
• VCLEFT_a361 — Esp Brake Switch Invalid VCLEFT_a361_espBrakeSwitchInvalid EPB defaults to using IBST for brake switch detection but will fallback to ESP if IBST invalid
• VCLEFT_a362 — Ibst Pressed Esp Not Pressed Mismatch VCLEFT_a362_ibstPressedEspNotPressedMismatch IBST detected brake pressed and ESP did not detected brake pressed
• VCLEFT_a363 — Ibst Not Pressed Esp Pressed Mismatch VCLEFT_a363_ibstNotPressedEspPressedMismatch IBST detected brake not pressed and ESP detected brake pressed
• VCLEFT_a364 — Esp Master Cyl Comp Over Threshold VCLEFT_a364_espMasterCylCompOverThreshold The ESP_masterCylOffsetComp signal was over the maximum expected value for 500ms
• VCLEFT_a365 — Too Steep To Park With Trailer Warning VCLEFT_a365_TooSteepToParkWithTrailerWarning Road grade is too steep to secure vehicle and trailer with Park Brake
• VCLEFT_a366 — Too Steep To Park With Trailer Un Sec Env VCLEFT_a366_TooSteepToParkWithTrailerUnSecEnv One Electronic Parking Brake (EPB) not applied, and road grade is too steep to secure vehicle and trailer with only one EPB
• VCLEFT_a370 — No LV Support Soc Too Low VCLEFT_a370_noLVSupportSocTooLow The high voltage (HV) battery state of charge (SOC) is not sufficient to complete a low voltage (LV) battery recharge cycle. The LV battery may become completely discharged, and the vehicle electrical system may have inadequate support.
• VCLEFT_a371 — Failure To Precharge Risk VCLEFT_a371_failureToPrechargeRisk Based on historical data, the vehicle controller determines there is a high probability the low voltage (LV) battery will not successfully precharge the high voltage (HV) bus.
• VCLEFT_a372 — T LVBMS Bmb Hw Over Voltage Fault VCLEFT_a372_TLVBMS_BmbHwOverVoltageFault A Battery Monitoring Board (BMB) device has detected an over voltage condition
• VCLEFT_a376 — Controller Wakeup Debug VCLEFT_a376_controllerWakeupDebug Debug Data capture event on front controller wakeup.
• VCLEFT_a377 — Wiper Park Fault VCLEFT_a377_wiperParkFault The wiper is experiencing a condition affecting movement from/to the park position
• VCLEFT_a378 — Wiper ECU Debug VCLEFT_a378_wiperECUDebug This alert is primarily informational and intended for collecting information related to wiper electronic control unit (ECU) behavior when ECU alerts / warnings have been set
• VCLEFT_a379 — Shorted Cell Test Run Debug VCLEFT_a379_shortedCellTestRunDebug Capture info useful for debugging: the load current, lowest voltage, lowest unfiltered voltage, time spent below voltage threshold.
• VCLEFT_a380 — Left Rear Body Side Light MIA VCLEFT_a380_leftRearBodySideLightMIA The load voltage does not meet the power source voltage in the expected amount of time.
• VCLEFT_a381 — Left Rear Body Side Light Internal Error VCLEFT_a381_leftRearBodySideLightInternalError An internal condition affecting the left rear body side light functionality has been detected - certain light functions may be degraded or disabled.
• VCLEFT_a387 — Shorted Cell Instc VCLEFT_a387_shortedCellInstc The low voltage (LV) battery has failed a test that checks for shorted battery cells. May indicate the LV battery has a shorted cell and is unable to fully support the LV electrical system. Note: A single failure of this test does not reli…