VCLEFT_a229 — No Drive Chg Cable Con

Full alert identifier: VCLEFT_a229_noDriveChgCableCon

Alert description

Drive has been requested while a charge cable is connected to the vehicle. The vehicle cannot enter drive until the charge cable has been disconnected.

Potential impact

Vehicle will not drive until the charge cable is disconnected.

Set condition

Drive request while a charge cable is connected to the vehicle.

Clear condition

Charge cable is disconnected from the vehicle.

Signals to check

These diagnostic fields are associated with VCLEFT_a229. Check the alert's Alert Log in Service Mode Plus for available values.

Signal	Unit
No Drive Chg Cable Con X `VCLEFT_a229_noDriveChgCableConX`	—

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of VCLEFT_a229.

VCLEFT_a121 — N Drive Fault VCLEFT_a121_nDriveFault The DRV motor driver bridge IC has indicated it has a fault condition when the bridge was active
VCLEFT_a120 — DI DRIVE MIA VCLEFT_a120_DI_DRIVE_MIA One or more of the messages the vehicle controller receives periodically from the front drive inverter (DIF) electronic control unit (ECU) is not received, indicating the DIF ECU may be unavailable (MIA).
VCLEFT_a230 — Drive Not Authed VCLEFT_a230_driveNotAuthed Drive has been requested without key authentication.
VCLEFT_a165 — Drive Blckd By Showroom VCLEFT_a165_driveBlckdByShowroom The vehicle is unable to drive because it has been placed in Showroom Mode, a mode intended for display rather than driving. This should not occur with a production vehicle once it has been delivered. If this occurs due to an error, servic…
VCLEFT_a338 — Drive Blckd By Msmtch VCLEFT_a338_driveBlckdByMsmtch The vehicle has detected at least one electronic control unit (ECU) running a firmware (software) version that may not be compatible with the firmware installed on the rest of the vehicle. When this occurs, the vehicle controller blocks dr…

Browse all VCLEFT alert codes