Primary electric power-assisted steering alerts

EPASTP alert codes

Showing 101–150 of 269

• EPASTP_a101 — Sdrv Spc Id Mismatch EPASTP_a101_sdrvSpcIdMismatch This alert is reported by the SENTDriverCD_TC3x component when there is a TSU sensor failure or connection failure.
• EPASTP_a102 — Am Phasecurrent Qos Err EPASTP_a102_amPhasecurrentQosErr This alert is reported by the ActuatorManager_R12 (AM) component when there is a current measurement failure.
• EPASTP_a103 — Exha Unused Interrupt Call Exception EPASTP_a103_exhaUnusedInterruptCallException This alert is reported by the ExceptionHandler_TC3x (EXHA) component when there is an unexpected interrupt on either core.
• EPASTP_a104 — Exha Bus Mpu Exception EPASTP_a104_exhaBusMpuException This alert is reported by the ExceptionHandler_TC3x (EXHA) component when there is a bus level MPU violation
• EPASTP_a105 — Exha Sri Bus Err Exception EPASTP_a105_exhaSriBusErrException This alert is reported by the ExceptionHandler_TC3x (EXHA) component when there is a SRI bus violation.
• EPASTP_a106 — Exha Spb Bus Err Exception EPASTP_a106_exhaSpbBusErrException This alert is reported by the ExceptionHandler_TC3x (EXHA) component when there is a SPB bus violation
• EPASTP_a107 — Exha Other Nmi Exception EPASTP_a107_exhaOtherNmiException This alert is reported by the ExceptionHandler_TC3x (EXHA) component when there is NMI caused by other alarms. Memory access violation check. This diagnostic checks if a thread or other bus master (e.g. DMA) tries to access memory region t…
• EPASTP_a108 — Exha Internal Protection Exception EPASTP_a108_exhaInternalProtectionException This alert is reported by the ExceptionHandler_TC3x (EXHA) component when there is a internal Protection exception
• EPASTP_a109 — Exha Sys Bus Or Periph Err Exception EPASTP_a109_exhaSysBusOrPeriphErrException This alert is reported by the ExceptionHandler_TC3x (EXHA) component when there is a system Bus or Peripheral Error exception other than a floating point exception
• EPASTP_a110 — Am Phase Relay Switch Off Test EPASTP_a110_amPhaseRelaySwitchOffTest This alert is reported by ActuatorManager_R12 (AM) component when there is a phase relay shorted.
• EPASTP_a111 — Am Current Sensing Disconnection EPASTP_a111_amCurrentSensingDisconnection This alert is reported by ActuatorManager_R12 (AM) component when there is a GDU failure or current sensing failure
• EPASTP_a112 — Rsth Safety Flipflop Err EPASTP_a112_rsthSafetyFlipflopErr This alert is reported by the HwResetHandler_TC3x (RSTH) component when there is a failure to correct data error in critical MCU registers.
• EPASTP_a113 — Rsth Uncorrectable End To End Bus Err EPASTP_a113_rsthUncorrectableEndToEndBusErr This alert is reported by the HwResetHandler_TC3x (RSTH) component when there is a MCU internal bus fault.
• EPASTP_a114 — Oseh Os Err EPASTP_a114_osehOsErr This alert is reported by the OsErrorHandler_R12 (OSEH) component at startup after an immediate reset caused by OS error occurred in ASIL D partition. This diagnostic monitors if the OS had sensed some error in its services.
• EPASTP_a115 — Mcussc Lbist Single Fail EPASTP_a115_mcusscLbistSingleFail This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when there is a MCU failure. Logic built-in self-test failed.
• EPASTP_a116 — Mrcc Startup Reg Cs Error Static Err EPASTP_a116_mrccStartupRegCsErrorStaticErr This alert is reported when the Start-up register check failed: MCU internal error OR SW systematic failure
• EPASTP_a117 — Mrcc Startup Reg Cs Error Transient Err EPASTP_a117_mrccStartupRegCsErrorTransientErr This alert is reported when there is a transient CRC failure in register CRC check.
• EPASTP_a118 — Mcussc Flash Cs Error Err EPASTP_a118_mcusscFlashCsErrorErr This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when the flashed SW is incorrect or flash memory failure. Calculated CRC not matching stored CRC.
• EPASTP_a119 — Mcussc Flash Ecc Critical Err EPASTP_a119_mcusscFlashEccCriticalErr This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when the flashed SW is incorrect or flash memory failure.
• EPASTP_a120 — Mcussc Flash Ecc Latent Err EPASTP_a120_mcusscFlashEccLatentErr This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when the flashed SW is incorrect or flash memory failure.
• EPASTP_a121 — Mcussc Mbist Ecc Err EPASTP_a121_mcusscMbistEccErr This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when the memory Built-In-SelfTest failed, errors in the critical memory units. MCU failure
• EPASTP_a122 — Pcp Bridge Fet Short EPASTP_a122_pcpBridgeFetShort This alert is reported by the PhaseCurrentProvider_R12 (PCP) component if both primary and secondary current measurement channels are in saturation state and the debounce counter reaches its limit. If both current measurement channels are…
• EPASTP_a123 — Imcm Comm Err EPASTP_a123_imcmCommErr This alert is reported when there is a Inter-MCU comm failure or other side is not communicating (UV or other failure).
• EPASTP_a124 — Mcussc Mbist Ecc Transient Err EPASTP_a124_mcusscMbistEccTransientErr This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when the memory Built-In-SelfTest failed, MCU failure.
• EPASTP_a125 — Mcussc Mbist Mia Err EPASTP_a125_mcusscMbistMiaErr This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when the memory Built-In-SelfTest failed, MCU failure
• EPASTP_a126 — Mcussc Monbist Mia Err EPASTP_a126_mcusscMonbistMiaErr This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when the Secondary Monitor and Standby SMU Built in Self Test failure, MCU failure
• EPASTP_a127 — Exch Additional Exception After Rst EPASTP_a127_exchAdditionalExceptionAfterRst This alert is reported by the ExceptionHandler_TC3x (EXCH) component when exception with reset before the previous similar error was reported. The alert is reported after reset if several exceptions in ASIL D partition were caught before…
• EPASTP_a128 — Exch Exception Stop Restart EPASTP_a128_exchExceptionStopRestart This alert is reported by the ExceptionHandler_TC3x (EXCH) component when exception with reaction other than reset
• EPASTP_a129 — Exch Additional Exception Stop Restart EPASTP_a129_exchAdditionalExceptionStopRestart This alert is reported by the ExceptionHandler_TC3x (EXCH) component when no-reset exception occured before the previous similar exception was reported
• EPASTP_a130 — Mrcc Config Cs Error Err EPASTP_a130_mrccConfigCsErrorErr This alert is reported when there is a CRC failure in the periodic register CRC checking. MCU internal error OR SW systematic failure
• EPASTP_a131 — Exch Guarded Reset After Partition Stop EPASTP_a131_exchGuardedResetAfterPartitionStop This alert is reported by the ExceptionHandler_TC3x (EXCH) component when no-reset exception occurred before the previous similar exception was reported and guarded reset was requested
• EPASTP_a132 — Mcussc Not Supported Mcu EPASTP_a132_mcusscNotSupportedMcu This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when the current MCU ID is not supported
• EPASTP_a133 — Mcussc Lbist Ecu Id Is Not Supported EPASTP_a133_mcusscLbistEcuIdIsNotSupported This alert is reported by MCUSafetyStartupChecks_TC3x (MCUSSC) component when wrong ECU_ID in FLASH
• EPASTP_a134 — Oseh Guarded Reset After Err Without Reset EPASTP_a134_osehGuardedResetAfterErrWithoutReset This alert is reported by the OsErrorHandler_R12(OSEH) component when ErrorHook was called because of an error in a partition which is configured to handle such errors with requesting a guarded reset. This error is reported after the guard…
• EPASTP_a135 — Tmpsfetj Calculation Overflow Err EPASTP_a135_tmpsfetjCalculationOverflowErr This alert is reported by the TemperatureModelPSFETJunction (TMPSFETJ) components when checking overflow of possible values of estimated temperatures. Possible values are calculated according to defined data constraints.
• EPASTP_a136 — Ft Electrical Angle Qf EPASTP_a136_ftElectricalAngleQf This alert is reported by the FrequencyTransformer_R12 (FT) component when the electrical angle QoS is Substitute Value or Error and RotorPositionAge tolerance time elapsed. This diagnostic compares the 2 local RPSs, and compares the local…
• EPASTP_a137 — Oseh Err Without Immediate Reset EPASTP_a137_osehErrWithoutImmediateReset This alert is reported by the OsErrorHandler_R12(OSEH) component when ErrorHook was called because of an error in a partition which is configured to handle such errors without requesting immediate safety reset.
• EPASTP_a138 — Oseh Additional Err Without Imm Reset EPASTP_a138_osehAdditionalErrWithoutImmReset This alert is reported by the OsErrorHandler_R12(OSEH) component when before reporting the previous error, ErrorHook was called again because of an error in a partition which is configured to handle such errors without requesting immediate…
• EPASTP_a139 — Oseh Additional Os Err EPASTP_a139_osehAdditionalOsErr This alert is reported when at startup, before reporting the previous error with the reset reaction, ErrorHook was called again because of an error in a partition which is configured to handle such errors with immediate safety reset. This…
• EPASTP_a140 — Imcm Configuration Err EPASTP_a140_imcmConfigurationErr This alert is reported in case of an Inter-MCU configuration mismatch between two ECU side.
• EPASTP_a141 — Am Fet Short Test EPASTP_a141_amFetShortTest This alert is reported when Bridge FET short may be present.
• EPASTP_a142 — Ted Emifilter Dmc Temp Checker EPASTP_a142_tedEmifilterDmcTempChecker This alert is reported if (DC Link capacitor temperature higher than limit or not available) for at least debounce limit long time. The alert is cleared, if the temperature is below the overtemp threshold, and its qualifier is RELIABLE fo…
• EPASTP_a143 — Ted Emifilter Cmc Temp Checker EPASTP_a143_tedEmifilterCmcTempChecker This alert is reported if (DC Link capacitor temperature higher than limit or not available) for at least debounce limit long time. The error is cleared, if the temperature is below the overtemp threshold, and its qualifier is RELIABLE for…
• EPASTP_a144 — Mri Core Raminit Failed EPASTP_a144_mriCoreRaminitFailed This alert is reported by the MCURamInit_TC3x (MRI) component when the memory initialization is failed when initializing the core RAM instances.
• EPASTP_a145 — Mri Peripheral Raminit Failed EPASTP_a145_mriPeripheralRaminitFailed This alert is reported by the MCURamInit_TC3x (MRI) component when the memory initialization is failed when initializing the peripheral RAM instances.
• EPASTP_a146 — Btarc Rc Circuit Check EPASTP_a146_btarcRcCircuitCheck This alert is reported by the BlackoutTimeAndResetCounter_R12 (BTARC) component when analog restart timer is working incorrectly. This diagnostic checks if the analog restart timer is working correctly.
• EPASTP_a147 — Am Dc Link Shorted Fail EPASTP_a147_amDcLinkShortedFail This alert is reported when there is a battery fet failure or DC link capacitor failure. Reported at runtime.
• EPASTP_a148 — Mrcc Exit From Standby Detected EPASTP_a148_mrccExitFromStandbyDetected This alert is reported when the wake-up (WKP) or overrun (OVRUN) bits is set in the PMSWSTAT2 register
• EPASTP_a149 — Am Reversible Emergency Off Requested EPASTP_a149_amReversibleEmergencyOffRequested This alert is reported by the ActuatorManager_R12 (AM) component when the external operating condition change.
• EPASTP_a150 — Am External Emergency Off Requested EPASTP_a150_amExternalEmergencyOffRequested This alert is reported by the ActuatorManager_R12 (AM) component when the external operating condition change.