Set the compressor to a target speed (800-7000 RPM). If sweep is disabled, the compressor will ramp to target RPM and hold that speed for 15 seconds. If sweep is enabled, the compressor will ramp to target RPM in 500 RPM increments and hold at final target RPM for 15 seconds. Note: The routine may skip some RPM values during sweep, or stop short of the target RPM. This is because some vehicles have certain speeds that are avoided.
PROC_X_COMPRESSOR-RPM-OVERRIDE
Model 3 / Y
Model S / X (2021+)
Used during a PWS retrofit. Sets the pedestrian warning speaker to either SPEAKER or EXT_SPEAKER_V2, depending on the vehicle platform.
PROC_ICE_X_SET-PEDESTRIAN-WARNING-SPEAKER-CONFIG
Model 3 / Y
Model S / X (2021+)
Alignment routine for new Continental radar installations
PROC_RADC_X_SERVICE-RADAR-ALIGNMENT-V2
Model 3 / Y
Model S / X (2021+)
Powers the accessory rail and runs HVAC pumps at maximum speed, changing valve positions.
Estimated time to complete is 10 minutes. Make sure the gateway remains unlocked for at least 12 minutes (720 seconds).
To exit the routine early, run this routine again with STOP as the input.
The controller will continue to run coolant air purge until it is completed or is requested to stop.
TEST_VCFRONT_X_THERMAL-COOLANT-AIR-PURGE
Model 3 / Y
Model S / X (2021+)
Starts the Coolant Purge Routine by running all pumps at maximum speed and changing valve positions. The routine will run for several minutes and will return a PASS if the routine started successfully. Vehicle must be in PARK gear and gateway unlocked.
TEST_VCFRONT_X_THERMAL-COOLANT-AIR-PURGE-START
Model 3 / Y
Model S / X (2021+)
Stops the Coolant Purge Routine and returns.
TEST_VCFRONT_X_THERMAL-COOLANT-AIR-PURGE-STOP
Model 3 / Y
Model S / X (2021+)
Tests for power, connection, and communication of the coolant fluid level sensor controlled by the Front Vehicle Controller (VCFRONT).
TEST-SELF_VCFRONT_X_COOLANT-FLUID-LEVEL
Model 3 / Y
Model S / X (2021+)
Identifies Coolant Pumps and returns the result after the routine finishes.
The pump will only be identified if the routine completes successfully.
TEST-SELF_VCFRONT_X_COOLANT-PUMPS-IDENTIFICATION
Model 3 / Y
Model S / X (2021+)
The self-test checks coolant valve (either the five-way valve or the octovalve) and calibrates the actuator controlled by the Front Vehicle Controller (VCFRONT) ECU.
TEST-SELF_VCFRONT_X_FIVE-WAY-VALVE
Model 3 / Y
Model S / X (2021+)
Tests for power, connection, and communication of the collant valve controlled by the Front Vehicle Controller (VCFRONT).
TEST-SELF_VCFRONT_X_THERMAL-COOLANT-VALVE
Model 3 / Y
Model S / X (2021+)
The test performs a UDS reset of the Charge Port (CP) Electronic Control Unit (ECU).
TEST-RESET_CP
Model 3 / Y
Model S / X (2021+)
Tests connection of damper valve to the Tesla Air Suspension (TAS) Electronic Control Unit (ECU).
TEST-SELF_TAS_X_DAMPER-VALVE-CONNECTION
Model S / X (2021+)
Performs an image capture while the Autopilot Electronic Control Unit (ECU) is in Calibration Mode.
The estimated time to complete is two minutes.
PROC_DAS_X_CAPTURE-IMAGE
Model 3 / Y
Model S / X (legacy)
Model S / X (2021+)
Clears the Driver's Assistance System (DAS) calibration data for select camera pairs or all cameras.
PROC_DAS_X_CLEAR-CALIBRATION
Model 3 / Y
Model S / X (legacy)
Model S / X (2021+)
Clears the lens hood occlusion alert from the camera health system.
PROC_DAS_X_CLEAR-LENS-HOOD-ALERT
Model 3 / Y
Model S / X (2021+)
Starts Calibration Mode on the Autopilot Electronic Control Unit (ECU). This routine is required so other routines can be executed.
PROC_DAS_X_ENTER-CALIBRATION-MODE
Model 3 / Y
Model S / X (legacy)
Model S / X (2021+)
Updates firmware on selected camera.
PROC_DAS_X_UPDATE-CAMERA
Model 3 / Y
Model S / X (2021+)
The Ethernet pings Ape-A, Ape-B, or both. After a reply is received, five pings are sent and the full ping output is returned.
Make sure to turn on the accessory drive rail. The estimated time to complete is one second per ping line output.
PING_DAS_X_ETHERNET-PING-DAS-ECUS
Model 3 / Y
Model S / X (legacy)
Model S / X (2021+)
Checks if the Driver's Assistance System (DAS) Electronic Control Unit (ECU) is connected and powered. Make sure to turn on the accessory drive rail and keep the DAS ECU awake to run the self test successfully.
PING-TP_DAS
Model 3 / Y
Model S / X (2021+)
Exit calibration mode on the Autopilot Electronic Control Unit (ECU).
PROC_DAS_X_EXIT-CALIBRATION-MODE
Model 3 / Y
Model S / X (legacy)
Model S / X (2021+)
Runs diagnostics on ASM330 IMU sensor's accelerometer and gyroscope.
PROC_DAS_X_IMU-CHECK
Model 3 / Y
Model S / X (2021+)
Resets the Driver's Assistance System (DAS) Electronic Control Unit (ECU) using the Controller Area Network (CAN) bus.
TEST-RESET_DAS
Model 3 / Y
Model S / X (legacy)
Model S / X (2021+)
The procedure sends a command to the Driver Assistance System (DAS) Service Application Programming Interface (API) and wakes DAS electronic control unit (ECU) if needed.
PROC_ICE_X_DAS-SERVICE-API
Model 3 / Y
Model S / X (legacy)
Model S / X (2021+)
Lists infotainment datavalues.
Apply filters in regular expression syntax to narrow the returned list.
TEST-BASH_ICE_X_LIST-DATAVALUES
Model 3 / Y
Model S / X (legacy)
Model S / X (2021+)