Left Etherloop vehicle controller alerts
Browse 175 EGGLEFTVC alert codes and open an entry for its description and recorded conditions.
EGGLEFTVC alert codes
Showing 151–175 of 175
- EGGLEFTVC_a380 — Steer Col Thermal Limited EGGLEFTVC_a380_steerColThermalLimited Steering column thermal protection mode is activated and user input was attempted, but blocked
- EGGLEFTVC_a383 — Steer Col In Out Motor Stall Current EGGLEFTVC_a383_steerColInOutMotorStallCurrent Steering column in/out motor is running at stall current
- EGGLEFTVC_a384 — Steer Col Up Down Motor Stall Current EGGLEFTVC_a384_steerColUpDownMotorStallCurrent Steering column up/down motor is running at stall current
- EGGLEFTVC_a385 — Steer Col In Out Motor Under Current EGGLEFTVC_a385_steerColInOutMotorUnderCurrent Steering column in/out motor current is too low while being driven
- EGGLEFTVC_a386 — Steer Col Up Down Motor Under Current EGGLEFTVC_a386_steerColUpDownMotorUnderCurrent Steering column up/down motor current is too low while being driven
- EGGLEFTVC_a387 — Steer Col In Out Motor Encoder Stalled EGGLEFTVC_a387_steerColInOutMotorEncoderStalled Steering column in/out motor encoder ticks not seen while being driven
- EGGLEFTVC_a388 — Steer Col Up Down Motor Encoder Stalled EGGLEFTVC_a388_steerColUpDownMotorEncoderStalled Steering column up/down motor encoder ticks not seen while being driven
- EGGLEFTVC_a389 — Steer Col In Out Encoder Out Of Range EGGLEFTVC_a389_steerColInOutEncoderOutOfRange Steering column in/out encoder out of range
- EGGLEFTVC_a390 — Steer Col Up Down Encoder Out Of Range EGGLEFTVC_a390_steerColUpDownEncoderOutOfRange Steering column up/down encoder out of range
- EGGLEFTVC_a414 — Undervoltage Self Test Failure EGGLEFTVC_a414_undervoltageSelfTestFailure The Left Domain Undervoltage self-test did not pass, as a condition affecting a load on the Left Domain was detected during the self-test.
- EGGLEFTVC_a415 — Undervoltage Self Test Stuck Off EGGLEFTVC_a415_undervoltageSelfTestStuckOff One or more loads failed to turn on during the Left Domain Undervoltage Self-Test. Those loads will be inhibited from use in drive.
- EGGLEFTVC_a444 — Drv8703 Fault EGGLEFTVC_a444_drv8703Fault The bridge gate driver experienced a condition affecting its operation.
- EGGLEFTVC_a445 — Drv8703 Spi Fault DBG EGGLEFTVC_a445_drv8703SpiFaultDBG DRV8703 bridge driver SPI data is unexpected
- EGGLEFTVC_a447 — Steering Col In Out Endstop Cal EGGLEFTVC_a447_steeringColInOutEndstopCal Steering column in / out motor end stop is not within the expected range.
- EGGLEFTVC_a448 — Steering Col Up Down Endstop Cal EGGLEFTVC_a448_steeringColUpDownEndstopCal Steering column up / down motor end stop is not within the expected range.
- EGGLEFTVC_a449 — Horn Switch Stuck On EGGLEFTVC_a449_hornSwitchStuckOn The steering wheel horn switch is stuck on
- EGGLEFTVC_a454 — Frunk Strut Position Mismatch EGGLEFTVC_a454_frunkStrutPositionMismatch The frunk leader and follower strut are no longer in sync with each other
- EGGLEFTVC_a455 — Frunk Strut Actuator Undercurrent EGGLEFTVC_a455_frunkStrutActuatorUndercurrent The vehicle controller detects an undercurrent condition on the front trunk (or frunk) strut actuator, indicating the 48V rail may be down.
- EGGLEFTVC_a458 — Vbus48 V Fused Rail Or Load Stuck On EGGLEFTVC_a458_vbus48VFusedRailOrLoadStuckOn Fused rail driver or downstream load driver cannot be turned off independently.
- EGGLEFTVC_a459 — Vbus48 V Fused Rail Test Diagnostics EGGLEFTVC_a459_vbus48VFusedRailTestDiagnostics Fused rail driver or downstream load driver test result stale.
- EGGLEFTVC_a460 — Exterior Frunk Button Inhibited EGGLEFTVC_a460_exteriorFrunkButtonInhibited A condition affecting frunk exterior button functionality has been detected.
- EGGLEFTVC_a471 — Emergency Frunk Button Press Ignored EGGLEFTVC_a471_emergencyFrunkButtonPressIgnored Frunk interior emergency release button press has been detected, but the frunk was not opened because vehicle was in motion.
- EGGLEFTVC_a485 — Uv Self Test Load Unattempted On Dbg EGGLEFTVC_a485_uvSelfTestLoadUnattemptedOnDbg The vehicle controller detects one or more loads did not turn off after the self-test commanded them off, or they did not turn on when the self-test commanded them on.
- EGGLEFTVC_a499 — Epbm Invalidate Cdp EGGLEFTVC_a499_epbmInvalidateCdp EPBM detected the CDP behavior was irrational and invalidated for drive cycle
- EGGLEFTVC_a520 — Config Mismatch EGGLEFTVC_a520_configMismatch The Electronic Parking Brake (EPB) configuration differs from the EPB configuration reported by Gateway (GTW). The Electronic Parking Brake Monitor (EPBM) expects the configuration from EPB to be valid based on GTW vehicle configuration.