TPMS UDS ECU Reset
The test resets the Tire Pressure Monitoring System (TPMS) ECU via UDS.
TEST-RESET_TPMS
The service task reference · 2026
Find the procedure. Understand what it does.
Explore diagnostic tests and repair tasks you can run with Tesware on compatible vehicles.
1,357
service tasks
2026 firmware
Model 3, Y, S & X
1,357 tasks Showing 1249–1272
Browse by name, A–Z
The test resets the Tire Pressure Monitoring System (TPMS) ECU via UDS.
TEST-RESET_TPMS
Tests whether the Trailer Light Controller (TLC) load is connected to the left vehicle controller (VCLEFT) ECU.
TEST_VCLEFT-TLC_REAR_TRAILER-CONTROLLER-CONNECTED
Tests whether the trailer light controller (TLC) load is disconnected from VCLEFT.
TEST_VCLEFT-TLC_REAR_TRAILER-CONTROLLER-DISCONNECTED
Tests communication of the Trailer Light Controller (TLC) Electronic Control Unit (ECU). Communication is established over the Local Interconnect Network (LIN) bus network.
TEST_VCLEFT-TLC_REAR_TRAILER-LIN-COMM
Runs all required routines after a Tesla Restraints Control Module (TRCM) replacement and arms the system.
PROC_TRCM_X_SERVICE-TASKS
Checks communication with the Tesla Restraints Control Module (TRCM). Communication is established through Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
PING-TP_TRCM
The procedure triggers an Odin Patch installation if a patch is available for the vehicle's installed firmware signature.
PROC_ICE_X_INSTALL-PATCH
Triggers an Odin Patch uninstall to fall back to installed firmware
PROC_ICE_X_UNINSTALL-PATCH
ODIN checks with the ECU if a log upload is available. If it is, ODIN downloads the data and uploads it to garage logs.
PROC_ODIN_X_TRIGGER-ECU-LOG-UPLOAD
Tests for power, connection, and communication of the left trunk interior illumination controlled by the Left Vehicle Controller (VCLEFT).
TEST-SELF_VCLEFT_X_TRUNK-INTERIOR-LIGHT
Tests for power, connection, and communication of the right trunk interior illumination controlled by the Right Vehicle Controller (VCRIGHT).
TEST-SELF_VCRIGHT_X_TRUNK-INTERIOR-LIGHT
Tune radio by inputting BAND (AM/FM/DAB/XM) and FREQUENCY (station). PLEASE HAVE RADIO PANEL PULLED UP ON THE UI BEFORE RUNNING.
PROC_ICE_X_TUNE-RADIO
Tuner and Antenna Connection Check
TEST-BASH_CID_X_TUNER-ANTENNA-ALL
Perform a tuner and antenna connection check.
TEST-BASH_CID_X_TUNER-ANTENNA
Based on vehicle configuration, corresponding option of tuner is checked.
TEST-BASH_CID_X_TUNER-ANTENNA-ALL
This checks the connections of tuner and antenna.
TEST-BASH_CID_X_TUNER-ANTENNA-APAC-BASE
This checks the connections of tuner and antenna.
TEST-BASH_CID_X_TUNER-ANTENNA-APAC-PREMIUM
This checks the connections of tuner and antenna.
TEST-BASH_CID_X_TUNER-ANTENNA-EU
This checks the connections of tuner and antenna.
TEST-BASH_CID_X_TUNER-ANTENNA-NA-BASE
This checks the connections of tuner and antenna.
TEST-BASH_CID_X_TUNER-ANTENNA-NA-PREMIUM
This checks the connections of tuner and antenna.
TEST-BASH_CID_X_TUNER-ANTENNA-ROW
Turns off an individual e-fuse power feed for the selected component. The channel powers down respecting the going-down timer. When the timeout expires, power is restored automatically.
PROC_VC_X_POWER-OFF-REQUEST
Turn on the accessory (ACC) power rail.
PROC_CID_X_ACC-RAIL-ON
Turn on the interior cabin map lights.
PROC_ICE_X_MAP-LIGHTS-ON
Descriptions and input definitions come from Tesla’s 2026 vehicle firmware. This catalog includes tasks covered by Tesware’s current service access. Each task page lists the vehicle and firmware versions in which it was found. The connected vehicle confirms whether a task can run.
Cybertruck is not included in this 2026 reference.