Clear DTCs
Clears the diagnostic data on the chosen Electronic Control Unit (ECU). This will clear any active Diagnostic Trouble Codes (DTC). DTC functionality may not exist on all ECUs depending on the platform.
PROC_X_CLEAR-DTCS
Find the procedure. Understand what it does.
Explore diagnostic tests and repair tasks you can run with Tesware on compatible vehicles.
1,357
service tasks
Model 3, Y, S & X
857 tasks Showing 97–120
Clear filtersClears the diagnostic data on the chosen Electronic Control Unit (ECU). This will clear any active Diagnostic Trouble Codes (DTC). DTC functionality may not exist on all ECUs depending on the platform.
PROC_X_CLEAR-DTCS
Restore power for a specific component by clearing its power-off request. Normal power management resumes and the feed turns back on per the vehicle's power state table.
PROC_VC_X_CLEAR-POWER-OFF-REQUEST
Clears Diagnostic Trouble Codes (DTCs) from the electrically assisted power steering (EPAS3P and EPAS3S) electronic control units (ECUs).
PROC_EPAS_X_CLEAR-DTCS
Clear all headlamp factory latched faults that were triggering leftHeadlampFactoryFault and rightHeadlampFactoryFault alerts
PROC_VCFRONT_X_CLEAR-HEADLAMP-LATCHED-FACTORY-FAULTS
Clears the Voltage Sense harness (VSH) alert BMS_a119_Fast_Open_Vsh_Detected latch within the HVBMS NVRAM. This routine shall only be executed after installing a new/remanufactured HV battery.
PROC_HVBMS_X_RESET-VSH-FAULT
Clears the HVC battery coolant flood alert, BMS_a124_Battery_Coolant_Flood, if set. This routine shall only be executed after repairing the HV battery isolation issue.
PROC_HVC_X_CLEAR-BATTERY-COOLANT-FLOOD-ALERT
Clears the HVC internal isolation alert, BMS_a123_SW_Internal_Isolation, if set. This routine shall only be executed after repairing the HV battery isolation issue.
PROC_HVC_X_CLEAR-INTERNAL-ISOLATION-ALERT
Clears the High Voltage Controller (HVC) isolation counters and alerts BMS_a027_SW_Repeated_Isolation_Failure_In_Drive, BMS_a172_SW_Isolation_Failure_In_Drive_Warning, BMS_a123_SW_Internal_Isolation, and BMS_a124_Battery_Coolant_Flood, if set. This routine shall only be executed after repairing a HV system component for loss of isolation.
PROC_HVC_X_CLEAR-ISOLATION-CONDITION
Clears the HVC SOC1 snapshot which in effect clears all HV battery brick weak short calculations and BMS_a029_dSoc_Limiting, if set. This routine shall only be executed after installing a new/remanufactured HV battery.
PROC_HVC_X_CLEAR-SOC1-SNAPSHOT
Clear the Mando Decoupled Brake (IDB) Diagnostic Trouble Codes (DTC).
PROC-IDB_X_CLEAR_DTCS
Clear all left headlamp factory latched faults that were triggering leftHeadlampFactoryFault alert
PROC_VCFRONT2_X_CLEAR-HEADLAMP-LATCHED-FACTORY-FAULTS
The procedure clears the Lost and Found folder to free up disk space.
PROC_ICE_X_CLEAR-LOST-FOUND
The procedure clears infotainment map cache to free up disk space. Confirm map cache is over 2.1GB.
PROC_ICE_X_CLEAR-MAP-CACHE
The procedure clears the media server caches to free up disk space.
PROC_ICE_X_CLEAR-MEDIA-CACHE
Clears the load shedding from the Vehicle Controller.
PROC_VCBATT2_X_CLEAR-POST-CRASH-LOADSHEDDING
Clears the load shedding from the Vehicle Front Controller (VCFRONT).
PROC_VCFRONT_X_CLEAR-POST-CRASH-LOADSHEDDING
Clear the Mando Redundant HCU (RCU) Diagnostic Trouble Codes (DTC).
PROC-RCU_X_CLEAR_DTCS
The procedure allows remote Service Alerts and remote notifications to be cleared.
PROC_ICE_X_CLEAR-REMOTE-ALERTS
Clear all right headlamp factory latched faults that were triggering rightHeadlampFactoryFault alert
PROC_VCBATT2_X_CLEAR-HEADLAMP-LATCHED-FACTORY-FAULTS
Executes a routine to clear the side view mirror fold actuator type auto-detected by the Tesla ECU.
PROC_X_CLEAR-MIRROR-FOLD-TYPE
The procedure clears the Spotify cache to free up disk space.
PROC_ICE_X_CLEAR-SPOTIFY-CACHE
The procedure clears existing Spotify credentials.
PROC_ICE_X_CLEAR-SPOTIFY-CREDS
The procedure clears all updater backups from the Infotainment and Connectivity ECU (ICE). This Task will only run if the filesystem has run out of inodes, otherwise it will cancel.
PROC_ICE_X_CLEAR-UPDATER-BACKUPS
Tests communication with the Compressor (CMP) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
PING-TP_CMP