PM_a064 — Torque Intervention

Full alert identifier: PM_a064_torqueIntervention

Message shown in the car

PULL OVER IMMEDIATELY - Unable to drive Exiting and re-entering vehicle may restore operation

Pedal Monitor Warning: Torque Intervention.

The safety monitor will inhibit torque and excess heat production for the remainder of the drive cycle.

The safety monitor sets this condition and indicates diagnostic information in its payload for root cause analysis.

This alert will clear on the next drive cycle.

These diagnostic fields are associated with PM_a064. Check the alert's Payload in Service Mode Plus for available values.

Signal	Unit
UI Stopping Mode `PM_a064_UI_stoppingMode` 0 STANDARD 1 CREEP 2 HOLD	—
Di Crs State `PM_a064_diCrsState` 0 UNAVAILABLE 1 STANDBY 2 ENABLED 3 STANDSTILL 4 OVERRIDE 5 FAULT 6 PRE FAULT 7 PRE CANCEL	—
Intervention Type `PM_a064_interventionType`	—
Pm Crs State `PM_a064_pmCrsState` 0 UNAVAILABLE 1 STANDBY 2 ENABLED 3 STANDSTILL 4 OVERRIDE 5 FAULT 6 PRE FAULT 7 PRE CANCEL	—
Short Detected By DI `PM_a064_shortDetectedByDI`	—
Torque Cmd State `PM_a064_torqueCmdState` 0 SNA 6 Valid 8 Invalid	—

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of PM_a064.