PM_a063 — Torque Command Inhibit
Full alert identifier: PM_a063_torqueCommandInhibit
Alert description
Pedal Monitor Fault: Torque Command Qualifier set to faulted
Potential impact
The safety monitor will disable innhibit torque production for the remainder of the drive cycle.
Set condition
The safety monitor sets this condition torque production error is detected
Clear condition
This alert will clear on the next drive cycle.
Signals to check
Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.
| Signal | Unit |
|---|---|
Total System Torque Command
PM_
|
Nm |
Total System Torque Measured
PM_
|
Nm |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of PM_a063.