PM_a046 — Incons Vehicle Hold State

Full alert identifier: PM_a046_inconsVehicleHoldState

Alert description

Pedal Monitor Warning: Inconsistent Vehicle Hold state.

The safety monitor will disable vehicle hold for the remainder of the drive cycle.

The safety monitor sets this condition when sensor or other ECU inputs into vehicle hold are deemed implausible.

This alert will clear on the next drive cycle.

Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.

Signal	Unit
Di Brake Torque Command `PM_a046_diBrakeTorqueCommand`	Nm

Signal	Unit
Di Brake Command Type `PM_a046_diBrakeCommandType`	—
Di Vhld State `PM_a046_diVhldState` 0 UNAVAILABLE 1 STANDBY 2 BLEND IN 3 STANDSTILL 4 BLEND OUT 5 PARK 6 FAULT 7 INIT	—
Pm Vhld State `PM_a046_pmVhldState` 0 UNAVAILABLE 1 STANDBY 2 BLEND IN 3 STANDSTILL 4 BLEND OUT 5 PARK 6 FAULT 7 INIT	—
Vhld Fault Reason `PM_a046_vhldFaultReason` 0 NONE 1 EBR FAULT 2 BRAKE INVALID 3 ESP FAULT 4 ESP MIA 5 EPB MIA 6 WHEEL SPDS INVAL 7 REQUESTED	—
Vhld Unavailable Reason `PM_a046_vhldUnavailableReason`	—

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of PM_a046.