PM_a043 — Inconsistent Config
Full alert identifier: PM_a043_inconsistentConfig
Alert description
Pedal Monitor Warning: PM and GTW config is Inconsistent.
Potential impact
The safety monitor will initiate a unit limp condition for the remainder of the drive cycle.
Set condition
The safety monitor sets this condition when the drive inveter component configuration mismatches with the platform configuration.
Clear condition
This alert will clear on the next drive cycle.
Signals to check
These diagnostic fields are associated with PM_a043. Check the alert's Payload in Service Mode Plus for available values.
| Signal | Unit |
|---|---|
GTW Autopilot
PM_
|
— |
GTW Chassis Type
PM_
|
— |
GTW Das Hw
PM_
|
— |
GTW Drivetrain Type
PM_
|
— |
GTW Vdc Type
PM_
|
— |
Brake HW Type
PM_
|
— |
Cabin PTC Heater Type
PM_
|
— |
Config Inconsistent
PM_
|
— |
Show 8 more fields
| Signal | Unit |
|---|---|
Expected Autopilot
PM_
|
— |
Expected Chassis Type
PM_
|
— |
Expected Drivetrain Type
PM_
|
— |
Expected Vdc Type
PM_
|
— |
Pack Energy
PM_
|
— |
Pack Performance Deviation
PM_
|
— |
Performance Package
PM_
|
— |
Soft Performance Limit
PM_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of PM_a043.