Rear vehicle controller alerts

VCREAR alert codes

Showing 151–200 of 250

• VCREAR_a243 — Bdw Unavailable VCREAR_a243_bdwUnavailable Brake Disc Wipe algorithm is not running due to loss of input signal(s)
• VCREAR_a244 — Winch Mode Active VCREAR_a244_WinchModeActive Non user facing alert set for service set when winch mode is active
• VCREAR_a245 — Service Mode Active VCREAR_a245_serviceModeActive User facing to warn that Electronic Parking Brake is in service mode and many Electronic Parking Brake features are disabled
• VCREAR_a246 — Idle Fault Apply VCREAR_a246_idleFaultApply Electronic Parking Brake apply failed due to idle fault
• VCREAR_a247 — Csm Dynamic Apply Retry VCREAR_a247_csmDynamicApplyRetry Electronic Parking Brake apply was interrupted during dynamic apply. Apply will be retried.
• VCREAR_a248 — Csm Dynamic Apply Failed VCREAR_a248_csmDynamicApplyFailed Electronic Parking Brake apply was interrupted during dynamic apply. Apply failed.
• VCREAR_a249 — Idle Fault Release VCREAR_a249_idleFaultRelease Electronic Parking Brake release failed due to idle fault
• VCREAR_a250 — Winch Mode Canceled VCREAR_a250_WinchModeCanceled Electronic Parking Brake has detected a vehicle speed condition that caused it to exit winch mode.
• VCREAR_a251 — Current Variance High VCREAR_a251_currentVarianceHigh Electronic Parking Brake noticed very noisy current
• VCREAR_a252 — Winch Mode Pending VCREAR_a252_winchModePending Electronic Parking Brake is preparing to enter winch mode
• VCREAR_a253 — Esm Release Blocked VCREAR_a253_esmReleaseBlocked Electronic Parking Brake is preventing calipers from opening
• VCREAR_a254 — Show Stalk Park Button Fault On Ui VCREAR_a254_showStalkParkButtonFaultOnUi Electronic Parking Brake has determined that the drive stalk park button has faulted and UI alert should be set allowing driver to park through UI
• VCREAR_a256 — Epb System Apply VCREAR_a256_epbSystemApply EPB parked the vehicle for a system reason
• VCREAR_a261 — Winch Mode Without Steering VCREAR_a261_winchModeWithoutSteering The Electronic Parking Brake (EPB) enabled Winch Mode but did not receive the expected messages from the steering system.
• VCREAR_a262 — Cannot Prepare Winch Mode VCREAR_a262_cannotPrepareWinchMode Non user facing alert set when user attempts to enter winch mode but a system reason prevents EPB from activating winch mode
• VCREAR_a263 — Epb Recovery Park VCREAR_a263_epbRecoveryPark The Electronic Parking Brake (EPB) attempted to park to establish vehicle security for Low Voltage system recovery.
• VCREAR_a264 — Winch Mode Deactivated VCREAR_a264_winchModeDeactivated Non user facing alert set when winch mode deactivates
• VCREAR_a272 — Vhcl Pwr State Msmtch VCREAR_a272_vhclPwrStateMsmtch Vehicle attempted a power state transition which the Electronic Parking Brake did not agree with.
• VCREAR_a273 — Left Rear Marker Light Fault VCREAR_a273_leftRearMarkerLightFault A condition affecting the left rear side marker light has been detected.
• VCREAR_a274 — Right Rear Marker Light Fault VCREAR_a274_rightRearMarkerLightFault A condition affecting the right rear side marker light has been detected.
• VCREAR_a275 — Left Reverse Light Fault VCREAR_a275_leftReverseLightFault A condition affecting the left reverse light has been detected.
• VCREAR_a276 — Right Reverse Light Fault VCREAR_a276_rightReverseLightFault A condition affecting the right reverse light has been detected.
• VCREAR_a277 — Left Bed Light Fault VCREAR_a277_leftBedLightFault A condition affecting the left bed light has been detected.
• VCREAR_a278 — Right Bed Light Fault VCREAR_a278_rightBedLightFault A condition affecting the right bed light has been detected.
• VCREAR_a281 — License Plate Light Fault VCREAR_a281_licensePlateLightFault A condition affecting the license plate light has been detected.
• VCREAR_a285 — Seat Heat Over Curr Rear Left VCREAR_a285_seatHeatOverCurrRearLeft The seat heater has had unusually high current draw.
• VCREAR_a286 — Seat Heat HSD Error Rear Left VCREAR_a286_seatHeatHSDErrorRearLeft The high side driver (HSD) for the rear left seat heater has detected an error condition, which may lead to the seat heater not performing as designed.
• VCREAR_a287 — Seat Heat Over Curr Rear Right VCREAR_a287_seatHeatOverCurrRearRight The seat heater has had unusually high current draw.
• VCREAR_a288 — Seat Heat HSD Error Rear Right VCREAR_a288_seatHeatHSDErrorRearRight The high side driver (HSD) for the rear right seat heater has detected an error condition, which may lead to the seat heater not performing as designed.
• VCREAR_a289 — Tonneau Tailgate Switch Fault VCREAR_a289_tonneauTailgateSwitchFault The tonneau and tailgate switches are being inhibited due to a switch voltage being out of bounds.
• VCREAR_a300 — Left Right Confusion VCREAR_a300_leftRightConfusion Electronic Parking Brake not sure if it is a left or a right.
• VCREAR_a301 — Ooc Speed Violation VCREAR_a301_oocSpeedViolation Vehicle speed is limited based on ultrasonic distance measurements. Currently in ghosted alert.
• VCREAR_a302 — Csm Long Release VCREAR_a302_csmLongRelease EPB releases no-load is measured using derivative of current. Currently in ghosted alert.
• VCREAR_a303 — Clamping Occured Early VCREAR_a303_clampingOccuredEarly When EPB was applying the current measured went above the max no load current before piston position estimate predicted it would.
• VCREAR_a350 — Ens Out Of Range VCREAR_a350_ensOutOfRange The Emergency Notification Signal (ENS) harness may be disconnected or the Restraints Control Module (RCM) may be missing (MIA).
• VCREAR_a353 — Missing Speed Unable To Park VCREAR_a353_missingSpeedUnableToPark EPB speed class is currently UNKNOWN and is not parked.
• VCREAR_a354 — Parked For Low Brake Fluid Mode VCREAR_a354_parkedForLowBrakeFluidMode Vehicle was in factory mode with low brake fluid and brake pedal was pressed causing EPB to park.
• VCREAR_a355 — Brake Hw And Epb Hw Mismatch VCREAR_a355_brakeHwAndEpbHwMismatch EPB calculate brake hw config and epb hw config independently and checks they are the same
• VCREAR_a356 — Parking For Stationary Detect VCREAR_a356_parkingForStationaryDetect Startionary detect can park vehicle if all speed sources are MIA and algo detects no motion.
• VCREAR_a357 — Brakes Too Hot For Slope VCREAR_a357_brakesTooHotForSlope Brake temperature is above 200C and slope is greater than 10%
• VCREAR_a358 — Brakes Too Hot For Slope With Only One Epb VCREAR_a358_brakesTooHotForSlopeWithOnlyOneEpb Brake temperature is above 200C and slope is greater than 5%
• VCREAR_a360 — Ibst Brake Switch Invalid VCREAR_a360_ibstBrakeSwitchInvalid EPB defaults to using IBST for brake switch detection but will fallback to ESP if IBST invalid
• VCREAR_a361 — Esp Brake Switch Invalid VCREAR_a361_espBrakeSwitchInvalid EPB defaults to using IBST for brake switch detection but will fallback to ESP if IBST invalid
• VCREAR_a362 — Ibst Pressed Esp Not Pressed Mismatch VCREAR_a362_ibstPressedEspNotPressedMismatch IBST detected brake pressed and ESP did not detected brake pressed
• VCREAR_a363 — Ibst Not Pressed Esp Pressed Mismatch VCREAR_a363_ibstNotPressedEspPressedMismatch IBST detected brake not pressed and ESP detected brake pressed
• VCREAR_a364 — Esp Master Cyl Comp Over Threshold VCREAR_a364_espMasterCylCompOverThreshold The ESP_masterCylOffsetComp signal was over the maximum expected value for 500ms
• VCREAR_a365 — Too Steep To Park With Trailer Warning VCREAR_a365_TooSteepToParkWithTrailerWarning Road grade is too steep to secure vehicle and trailer with Park Brake
• VCREAR_a366 — Too Steep To Park With Trailer Un Sec Env VCREAR_a366_TooSteepToParkWithTrailerUnSecEnv One Electronic Parking Brake (EPB) not applied, and road grade is too steep to secure vehicle and trailer with only one EPB
• VCREAR_a372 — Air Comp Over Current VCREAR_a372_airCompOverCurrent The air compressor for the air suspension system reports an overcurrent condition (current measurement is implausibly high).
• VCREAR_a382 — Right Rear Body Side Light MIA VCREAR_a382_rightRearBodySideLightMIA The right rear body side light is not communicating.