Vehicle gateway alerts

GTW alert codes

Showing 51–100 of 257

• GTW_w071 — Hrl Trigger GTW_w071_hrlTrigger Issue with triggering HRL
• GTW_w072 — Update Failure GTW_w072_updateFailure The vehicle gateway (GTW) detects that at least one electronic control unit (ECU) did not successfully install an update during an attempted vehicle software update. Version mismatch alerts should be present indicating any ECUs affected as…
• GTW_w073 — Steering Wheel Reset GTW_w073_steeringWheelReset The vehicle gateway (GTW) is cycling power (off, then on again) to the infotainment processor and touchscreen (UI) in response to user input via the steering wheel controls (a scroll-wheel reset request). This alert is primarily informatio…
• GTW_w074 — Epas3p MIA GTW_w074_epas3pMIA The vehicle gateway (GTW) has not received an expected system status message from the primary Electronic Power-Assisted Steering (EPAS3P) electronic control unit (ECU) via the controller area network (CAN) within the required time period,…
• GTW_w075 — Epas3s MIA GTW_w075_epas3sMIA The vehicle gateway (GTW) has not received an expected system status message from the secondary Electronic Power-Assisted Steering (EPAS3S) electronic control unit (ECU) via the controller area network (CAN) within the required time period…
• GTW_w076 — Eth Interface Reset GTW_w076_ethInterfaceReset An ethernet interface reset has occurred
• GTW_w077 — Bmp Pmic Error GTW_w077_bmpPmicError The vehicle gateway (GTW) has detected an error affecting the car computer infotainment processor (BMP) power management integrated circuit (PMIC). May indicate a hardware condition affecting the infotainment processor's power supply.
• GTW_w081 — Uds Message Rejected GTW_w081_udsMessageRejected Due to product security concerns, the vehicle gateway (GTW) has blocked a unified diagnostic services (UDS) message that the infotainment system attempted to send via GTW over a controller area network (CAN) bus. May result from a UDS mess…
• GTW_w082 — Sd Card BS Corrupted GTW_w082_sdCardBSCorrupted The vehicle gateway (GTW) detects its microSD card file system boot sector has become corrupted. The microSD card needs to be successfully formatted.
• GTW_w083 — Uds Msg Dropped By Tcp Stack GTW_w083_udsMsgDroppedByTcpStack Message dropped by TCP stack
• GTW_w084 — Can Frame Dropped GTW_w084_canFrameDropped Gateway was unable to transmit a frame as requested
• GTW_w086 — Ocu GTW_w086_ocu Offboard Charger Update error
• GTW_w087 — Ocu In Progress GTW_w087_ocuInProgress The vehicle gateway (GTW) is updating the software of an offboard charger, such as a mobile connector (UMC) or wall connector. These updates run when the vehicle has finished charging and the user is not interacting with it (prior to the v…
• GTW_w088 — Sd Card Inv Req Parallel GTW_w088_sdCardInvReqParallel Request can potentially cause sdcard corruption
• GTW_w089 — Sd Card Watchdog GTW_w089_sdCardWatchdog Couldn't communicate with the SD Card. SD Card will be reinited
• GTW_w090 — Ocu Failed GTW_w090_ocuFailed Offboard Charger Update failed
• GTW_w091 — Low Stack GTW_w091_lowStack Low task stack detected
• GTW_w092 — Sd Card Inv Req Zero GTW_w092_sdCardInvReqZero Request can potentially cause sdcard corruption
• GTW_w093 — Sd Card Inv Req Overflow Base GTW_w093_sdCardInvReqOverflowBase Request can potentially cause sdcard corruption
• GTW_w094 — Sd Card Inv Req Overflow Count GTW_w094_sdCardInvReqOverflowCount Request can potentially cause sdcard corruption
• GTW_w095 — Sd Card Full GTW_w095_sdCardFull Fatfs thinks it is full
• GTW_w096 — Sd Card Fat Corrupted GTW_w096_sdCardFatCorrupted Fatfs FAT area is corrupted. Format needed
• GTW_w101 — Switch Watchdog GTW_w101_switchWatchdog The processor running the User Interface (UI) does not respond to pings sent by the vehicle Gateway (GTW), causing the ethernet switch to reset.
• GTW_w103 — Sd Card Formatted GTW_w103_sdCardFormatted The SD Card was formatted
• GTW_w104 — Sd Card Driver Arg Corrupted GTW_w104_sdCardDriverArgCorrupted Possible FATFS corruption
• GTW_w105 — E Buck Configured GTW_w105_eBuckConfigured The vehicle gateway (GTW) detects the vehicle is configured as an Engineering Buck (eBuck), a setting intended for development purposes only and not available once the car computer is production-fused. If this alert is present on a product…
• GTW_w106 — BLEEPLEFT version Mismatch GTW_w106_BLEEPLEFTversionMismatch The vehicle gateway (GTW) detects the Bluetooth Low Energy End Point Left (BLEEPLEFT) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w107 — BLEEPRIGHT version Mismatch GTW_w107_BLEEPRIGHTversionMismatch The vehicle gateway (GTW) detects the Bluetooth Low Energy End Point Right (BLEEPRIGHT) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w108 — BLEEPREAR version Mismatch GTW_w108_BLEEPREARversionMismatch The vehicle gateway (GTW) detects the Bluetooth Low Energy End Point Rear (BLEEPREAR) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w109 — Failed To Start Updater GTW_w109_failedToStartUpdater The vehicle gateway (GTW) unsuccessfully attempted to run the GTW Updater application during a vehicle software update. May indicate a software bug that requires investigation or a condition affecting GTW microSD card integrity.
• GTW_w110 — Read Mdio Failed GTW_w110_readMdioFailed Failed to read an MDIO switch register
• GTW_w111 — Write Mdio Failed GTW_w111_writeMdioFailed Failed to write an MDIO switch register
• GTW_w112 — Z4b Disabled GTW_w112_z4bDisabled Z4B Core is not running as shown by MC_ME_CS
• GTW_w113 — Unrecognized Can Message GTW_w113_unrecognizedCanMessage The vehicle gateway (GTW) receives an unrecognized controller area network (CAN) message from another electronic control unit (ECU). May be caused by another ECU running a software version incompatible with the version installed on the GTW…
• GTW_w114 — Updt Retried GTW_w114_updtRetried Update automatically retried
• GTW_w115 — Hrl Event File Avail GTW_w115_hrlEventFileAvail HRL Event File available
• GTW_w116 — Switch Init Failed GTW_w116_switchInitFailed Failed to properly initialize the switch. Might see erratic network behavior
• GTW_w117 — Unexpected Destructive Reset Status GTW_w117_unexpectedDestructiveResetStatus An unexpected vehicle gateway (GTW) reset occurred due to a reason not listed in the GTW software, which can occur after a loss of low voltage (LV) power, among other reasons.
• GTW_w118 — Unexpected Functional Reset Status GTW_w118_unexpectedFunctionalResetStatus An unexpected vehicle gateway (GTW) reset occurred due to a reason not listed in the GTW software.
• GTW_w120 — Switch Unlocked GTW_w120_switchUnlocked Network switch is unlocked
• GTW_w125 — Switch Replay Unlocked GTW_w125_switchReplayUnlocked Network switch is unlocked for replay
• GTW_w126 — RCMPRIVATE can Fault GTW_w126_RCMPRIVATE_canFault The vehicle gateway (GTW) detects the RCMPPRIVATE bus is not functioning as expected, making communication over the RCMPPRIVATE bus limited or unavailable.
• GTW_w127 — No File Pointers Available GTW_w127_noFilePointersAvailable All file pointers are in use when GTW attempts to access one.
• GTW_w128 — Switch RGMII Port Comm Err GTW_w128_switchRGMIIPortCommErr Etherloop Switch Port RGMII interface (GTW port or ADSP port or both) is not functional
• GTW_w129 — ICR version Mismatch GTW_w129_ICRversionMismatch The vehicle gateway (GTW) detects the Interior Cabin Radar (ICR) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w130 — BLEEPFRONT version Mismatch GTW_w130_BLEEPFRONTversionMismatch The vehicle gateway (GTW) detects the Bluetooth Low Energy End Point Front (BLEEPFRONT) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w133 — Adsp Fault Detected GTW_w133_adspFaultDetected Indicates an early boot failure on ADSP due to HW or power sequence
• GTW_w134 — Disable Feature Failed GTW_w134_disableFeatureFailed A received UDP command to disable a feature failed
• GTW_w135 — Can Log Queue Full GTW_w135_canLogQueueFull Could not log CAN message. Queue full.
• GTW_w136 — Hrl Game Mode File Avail GTW_w136_hrlGameModeFileAvail HRL game mode file available