Rear Ultrasonic Sensor Address Programming
Programs the address of the rear Ultrasonic Sensors (USS).
PROC_USM_REAR_PROGRAM-USS-ADDRESSES
Find the procedure. Understand what it does.
Explore diagnostic tests and repair tasks you can run with Tesware on compatible vehicles.
1,357
service tasks
Model 3, Y, S & X
676 tasks Showing 481–504
Clear filtersPrograms the address of the rear Ultrasonic Sensors (USS).
PROC_USM_REAR_PROGRAM-USS-ADDRESSES
Configures Rear Left Drive Unit cooling Oil Pump sub-usage ID.
PROC_PMREL_X_WRITE-OPC2-TYPE
Calibrate resolver analog input error, required after an inverter swap. Before running routine, verify steering wheel is straight and drive rail is on. After starting routine, follow these steps to complete: 1. With vehicle on lift, shift to gear D within 10 seconds of starting routine, and firmly press accelerator pedal. 2. Keep accelerator pedal pressed until motor starts slowing down on its own. 3. After speedometer reaches 0, press the brake and shift to gear P. Do NOT press brakes during coast down, brake softly if cancelling routine.
PROC_DIREL_X_RESOLVER-ERROR-LEARN
Calibrate resolver analog input error, required after an inverter swap. Before running routine, verify steering wheel is straight and drive rail is on. After starting routine, follow these steps to complete: 1. With vehicle on lift, shift to gear D within 10 seconds of starting routine, and firmly press accelerator pedal. 2. Keep accelerator pedal pressed until motor starts slowing down on its own. 3. After speedometer reaches 0, press the brake and shift to gear P. Do NOT press brakes during coast down, brake softly if cancelling routine.
PROC_DIRER_X_RESOLVER-ERROR-LEARN
Records a new maintenance or repair event for this vehicle, adding to its service history database.
PROC_ICE_X_RECORD-SERVICE-ACTION
Refresh Gateway Config Message
PROC_ICE_X_GTW-REFRESH-CONFIG-MSG
Tests for power, connection, and communication of the refrigerant discharge sensor controlled by the Front Vehicle Controller (VCFRONT).
TEST-SELF_VCFRONT_X_REFRIGERANT-DISCHARGE
Model 3 Non-heat-pump ONLY - Refrigerant EXV Test
TEST-SELF_VCFRONT_X_CHILLER-EXV
Tests for power, connection, and communication of the refrigerant liquid sensor controlled by the Front Vehicle Controller (VCFRONT).
TEST-SELF_VCFRONT_X_REFRIGERANT-LIQUID
Tests for power, connection, and communication of the refrigerant suction sensor controlled by the Front Vehicle Controller (VCFRONT).
TEST-SELF_VCFRONT_X_REFRIGERANT-SUCTION
Clears current EPBL config and learns new config from gtw car configs. Only use after replacing EPB hardware where gtw config change was required.
PROC_EPBL_CLEAR-BRAKE-HW-TYPE
Clears current EPBR config and learns new config from gtw car configs. Only use after replacing EPB hardware where gtw config change was required.
PROC_EPBR_CLEAR-BRAKE-HW-TYPE
Provides RMI (Repair and Maintenance Information) Vitals values, including configuration values, alerts, and data.
PROC_ICE_X_RMI-VITALS
Requests the accessory rail and the drive rail to power off.
PROC_CID_X_REQUEST-RAILS-OFF
Request accessory power from the vehicle to wake up certain ECU's for a user specified number of seconds.
PROC_ICE_X_REQUEST-ACC-POWER
Turn off HVAC, equivalent to touching the power icon on the UI
PROC_ICE_X_REQUEST-HVAC-OFF
Requests the drive rail to power off and the high voltage battery pack contactors to open.
PROC_CID_X_REQUEST-HV-CONTACTORS-OPEN
Activates service wiper mode, allowing wiper to be in a service position.
PROC_ICE_X_REQUEST-WIPER-SERVICE-MODE
Run this routine after compressor replacement. Resets the compressor power index back to 100.
PROC_VCFRONT_X_RESET-COMPRESSOR-P-METRIC
Reset Das A or Das B updater remotely. This is useful for recovering Turbo if it gets stuck during a reboot loop.
PROC_MCU_X_INFO-DAS-UPDATER-RESET
The procedure resets the User Interface (UI) firmware update progress state.
PROC_ICE_X_RESET-UPDATE-PROGRESS
This routine resets the frunk latch open failure metric alert. Note that the frunk latch open failure metric is only active on single release actuator vehicles.
PROC_VCFRONT_X_RESET-FRUNK-OPEN-FAIL-METRIC
Clears the internal modem reset counter and resets modem via the connectivity stack API.
PROC_ICE_X_MODEM-RESET
Resets Radiator UA index, also known as the "Radiator Health Score" score, back to 100% - only run this routine after performing a radiator cleaning procedure.
PROC_VC_X_RESET-RADIATOR-UA-INDEX