Skip to content
Service procedures 2026 firmware

Check Continental Ride Height Calibration

ModelS/tasks/PROC_EAS_X_CHECK-RIDE-HEIGHT-CALIBRATION

Model S / X (legacy)

What this task does

Check ride height calibration of the Continental air suspension. Please input the ride height measured at each corner of the vehicle.

Vehicle & firmware coverage

Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.

Model S / X (legacy) Legacy infotainment · Firmware 2026.14.6
Vehicle coverage
Pre-2021 Model S
Supported connection
Local connection
Vehicle state
Stationary · Parked
Gateway diagnostic level
Factory, Service

Task inputs (4)

FL_floor_reading

FL_floor_reading · Int

Firmware default: Not specified

FR_floor_reading

FR_floor_reading · Int

Firmware default: Not specified

RL_floor_reading

RL_floor_reading · Int

Firmware default: Not specified

RR_floor_reading

RR_floor_reading · Int

Firmware default: Not specified

Related service tasks

Browse all tasks →
Service procedures

Continental Air Suspension Leveling

Levels the Continental Air Suspension to the selected target height. Low = 3, Standard = 4, High = 5, Very High = 6.

PROC_EAS_X_LEVEL-TO-HEIGHT

Model S / X (legacy)
Service procedures

EAS Deflate Component (CONTI)

Deflate an Electronic Air Suspension component. The EAS system can either deflate to the onboard reservoir or to the atmosphere. The routine can deflate to the reservoir or to ambient. If 'Ambient' is selected the system will release nitrogen to the atmosphere. A nitrogen tank is required to restore the air mass in the system after deflating to ambient. If 'Reservoir' is selected the system will deflate to the reservoir. Deflating to reservoir is unsupported in combination with targeted component "ALL". This network can also be run in two modes, "Complete" or "Timed". If 'Complete' is selected, the system will deflate the component completely. If 'Timed' is selected, the component will deflate for a short period of time.

PROC_EAS_X_DEFLATE

Model S / X (legacy)