ModelS/tasks/PROC_EAS_X_CALIBRATE-RIDE-HEIGHT
Calibrates the ride height of the Continental Air Suspension.
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
FL_floor_reading · Int
Front Left floor reading
Firmware default: Not specified
FR_floor_reading · Int
Front Right floor reading
Firmware default: Not specified
RL_floor_reading · Int
Rear Left floor reading
Firmware default: Not specified
RR_floor_reading · Int
Rear Right floor reading
Firmware default: Not specified
Check ride height calibration of the Continental air suspension. Please input the ride height measured at each corner of the vehicle.
PROC_EAS_X_CHECK-RIDE-HEIGHT-CALIBRATION
Exit service mode on Continental air suspension
PROC_EAS_X_FINISH-SERVICE
Levels the Continental Air Suspension to the selected target height. Low = 3, Standard = 4, High = 5, Very High = 6.
PROC_EAS_X_LEVEL-TO-HEIGHT
Deflate an Electronic Air Suspension component. The EAS system can either deflate to the onboard reservoir or to the atmosphere. The routine can deflate to the reservoir or to ambient. If 'Ambient' is selected the system will release nitrogen to the atmosphere. A nitrogen tank is required to restore the air mass in the system after deflating to ambient. If 'Reservoir' is selected the system will deflate to the reservoir. Deflating to reservoir is unsupported in combination with targeted component "ALL". This network can also be run in two modes, "Complete" or "Timed". If 'Complete' is selected, the system will deflate the component completely. If 'Timed' is selected, the component will deflate for a short period of time.
PROC_EAS_X_DEFLATE