Diagnostic tests
BMP Watchdog Enabled Check
This check succeeds if the gateway reports that the bmp watchog is enabled.
TEST_GTW_BMP-WATCHDOG-ENABLED
Model 3 / Y
Model S / X (2021+)
Diagnostic tests
2026 firmware
Test Gateway Fault Confinement and CAN Bus Activity
Model3/tasks/TEST-CAN_GTW
What this task does
Tests the Gateway's ability to confine faults and monitor controller area network (CAN) bus activity.
Vehicle & firmware coverage
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
Model 3 / Y AMD · Firmware 2026.32.3
- Vehicle coverage
- 2024+ Model 3, 2025+ Model Y, Model Y, Pre-2024 Model 3
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- No specific level listed
Procedure notes
During the test, certain vehicle functions relying on CAN bus communication may be temporarily unavailable.
Task inputs (0)
No user inputs are listed in this firmware.
Model 3 / Y Intel · Firmware 2026.32.7
- Vehicle coverage
- Model Y, Pre-2024 Model 3
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- No specific level listed
Procedure notes
During the test, certain vehicle functions relying on CAN bus communication may be temporarily unavailable.
Task inputs (0)
No user inputs are listed in this firmware.
Related service tasks
Browse all tasks →
Diagnostic tests
Enable BMP Watchdog
This network enables the BMP watchdog and exits with 0 if it was enabled successfully
TEST_GTW_ENABLE-BMP-WATCHDOG
Model 3 / Y
Model S / X (2021+)