Clear Post-Crash Load Shedding
Clears the load shedding from the Vehicle Controller.
PROC_VCBATT2_X_CLEAR-POST-CRASH-LOADSHEDDING
Gen3/tasks/PROC_VCBATT2_X_RESET-FRUNK-OPEN-FAIL-METRIC
This routine resets the frunk latch open failure metric alert. Note that the frunk latch open failure metric is only active on single release actuator vehicles.
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
This routine should only be run once the latch has been thoroughly inspected/replaced. Confirm latch is properly reporting open when physically open and switches are not damaged.
confirm · Bool
VCBATT2 frunk sensor degraded metric will be reset. Make sure frunk latch has been inspected/replaced before running it.
Firmware default: false
Clears the load shedding from the Vehicle Controller.
PROC_VCBATT2_X_CLEAR-POST-CRASH-LOADSHEDDING
Clear all right headlamp factory latched faults that were triggering rightHeadlampFactoryFault alert
PROC_VCBATT2_X_CLEAR-HEADLAMP-LATCHED-FACTORY-FAULTS
Tests communication with the front vehicle controller (VCBATT2) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
PING-TP_VCBATT2
Checks the electrical connection of the LED light in front trunk emergency release switch controlled by the Front Battery Controller (VCBATT2).
TEST-SELF_VCBATT2_X_FRUNK-LED