UMC_a002 — GFCI Tripped

Full alert identifier: UMC_a002_GFCITripped

Message shown in the car

Unable to charge - Mobile Connector GFCI tripped Unplug charge handle from charge port and retry

UMC ground leakage current exceeded threshold

UMC will not charge until the ground fault is corrected. UMC will retest after 15 minutes (except when an EU smart adapters) or charge cable cycle

A ground fault current exceeding detection threshold was detected

Ground fault path has been corrected and the test was re-run after 15 minutes (non-EU) or cable cycle

Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.

Signal	Unit
Ccid DC Gfci Current `UMC_a002_ccidDCGfciCurrent`	A
Ccid Rms Current `UMC_a002_ccidRmsCurrent`	A
Ccid Rms Current Avg `UMC_a002_ccidRmsCurrentAvg`	A

Signal	Unit
Ccid Fault Bucket `UMC_a002_ccidFaultBucket`	—
Ccid Fault Reason `UMC_a002_ccidFaultReason` 0 SNA 1 AC LPF 2 AC PEAK 3 DC LPF 4 DC PEAK	—

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of UMC_a002.