TAS_a232 — Suspension Type Mismatch

Full alert identifier: TAS_a232_suspensionTypeMismatch

Alert description

The suspension type configuration value reported by the vehicle gateway (GTW) does not match the suspension type type supported by the firmware version running on the Tesla Air Suspension (TAS) electronic control unit (ECU).

Potential impact

No expected impact on vehicle functionality.

Set condition

The TAS ECU detects a mismatch between the suspension type supported by its firmware and the suspension type reported by the GTW.

Clear condition

The suspension type reported by the GTW matches the suspension type supported by the TAS ECU firmware

Signals to check

These diagnostic fields are associated with TAS_a232. Check the alert's Payload in Service Mode Plus for available values.

Signal	Unit
Detected Suspension Type `TAS_a232_detectedSuspensionType` 0 UNKNOWN 1 NONE 2 CONTI STANDARD 3 CONTI PLUS 4 TESLA STANDARD 5 TESLA PLUS 6 TESLA ADAPTIVE	—
Expected Suspension Type `TAS_a232_expectedSuspensionType` 0 UNKNOWN 1 NONE 2 CONTI STANDARD 3 CONTI PLUS 4 TESLA STANDARD 5 TESLA PLUS 6 TESLA ADAPTIVE	—

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of TAS_a232.