SCCM_a012 — Turn Gen Err
Full alert identifier: SCCM_a012_turnGenErr
Message shown in the car
Turn indicator stalk error detected Re-entering vehicle may restore operation
Alert description
Steering Column Control Module (SCCM) detected a turn indicator sensor generic software error.
Potential impact
Turn indicator operation from gear stalk control may not operate as expected.
Set condition
SCCM detected a turn indicator sensor generic software error.
Clear condition
Inspect wiring to SCCM and/or re-flash. If error persists after several power cycles, replace SCCM.
Signals to check
Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.
| Signal | Unit |
|---|---|
Adc Value 1
SCCM_
|
— |
Adc Value 2
SCCM_
|
— |
Debounce Position
SCCM_
|
— |
Error Position
SCCM_
|
— |
Raw Position
SCCM_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of SCCM_a012.