HVP_w067 — Hvil Cal Node Mismatch
Full alert identifier: HVP_w067_HvilCalNodeMismatch
Message shown in the car
Vehicle configuration mismatch Service is required
Alert description
The High Voltage Interlock Loop (HVIL) type in the High Voltage Processor's (HVP) calibration block or firmware file does not match the expected configuration.
Potential impact
Contactors will open and may remain open while not in the drive state.
Set condition
The HVIL type determined by the HVP is mismatched with the numberHVILNodes gateway configuration.
Clear condition
The HVIL type determined by the HVP matches with the numberHVILNodes gateway configuration.
Signals to check
These diagnostic fields are associated with HVP_w067. Check the alert's Payload in Service Mode Plus for available values.
| Signal | Unit |
|---|---|
Hvil Type From Gateway
HVP_
|
— |
Hvil Type From Hvp
HVP_
|
— |
Hvil Type Is From Cal
HVP_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of HVP_w067.