DI_a162 — Shift Denied

Full alert identifier: DI_a162_shiftDenied

Alert description

The drive interface (DI) electronic control unit (ECU) receives a shift request but detects a condition that prevents the request from being honored.

User unable to shift until clear condition is resolved.

The DI ECU detects a condition that causes it to deny a shift request. Set reasons defined by the DI_shiftDeniedReason value-table.

The DI ECU detects that the condition clears.

Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.

Signal	Unit
Motor Speed `DI_a162_motorSpeed`	MPH
Pedal Pos `DI_a162_pedalPos`	%
Time Since Cruise Cancel `DI_a162_timeSinceCruiseCancel`	second

Signal	Unit
Autonomy Behavior `DI_a162_autonomyBehavior` 0 DRIVER 1 DRIVERLESS TAKEOVER 2 DRIVERLESS NO TAKEOVER	—
Charge Cable Connected `DI_a162_chargeCableConnected`	—
Current Gear `DI_a162_currentGear` 0 INVALID 1 P 2 R 3 N 4 D 7 SNA	—
Ess Cont Closed `DI_a162_essContClosed`	—
Frunk Open `DI_a162_frunkOpen`	—
Request Source `DI_a162_requestSource`	—
Requested Gear `DI_a162_requestedGear` 0 INVALID 1 P 2 R 3 N 4 D 7 SNA	—
Shift Denied Reason `DI_a162_shiftDeniedReason`	—

Show 1 more field

Signal	Unit
Sys State Exit Condition `DI_a162_sysStateExitCondition`	—

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of DI_a162.