CP_a089 — Plc Config Mismatch

Full alert identifier: CP_a089_plcConfigMismatch

Alert description

The charge port (CP) electronic control unit (ECU) detects that the Gateway (GTW) configuration for power line communication (PLC) does not match the CP ECU hardware configuration.

Potential impact

The GTW may be unable to update the PLC modem during firmware updates.

Set condition

The CP ECU detects that the GTW PLC support type does not match the CP ECU hardware configuration.

Clear condition

The CP ECU detects that the GTW PLC support type matches the CP ECU hardware configuration.

Signals to check

These diagnostic fields are associated with CP_a089. Check the alert's Payload in Service Mode Plus for available values.

Signal	Unit
Gtw Plc Support Type `CP_a089_gtwPlcSupportType` 0 NONE 1 GEN3 EU CP 2 NATIVE CHARGE PORT	—
Plc Modem Populated `CP_a089_plcModemPopulated`	—

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of CP_a089.