CP_a054 — Cable Not Secured

Full alert identifier: CP_a054_cableNotSecured

Message shown in the car

Charge port latch not engaged Fully insert charge cable or check for obstruction

Alert description

Charge port (CP) expects the cable to be secured, but the charge port latch has not secured the cable in place. AC charge rate may be reduced, and DC charging may be unavailable.

Potential impact

AC charge rate may be reduced, and DC charging may be unavailable.

Set condition

A charge cable is detected. The charge port (CP) latch position sensor indicates the latch is disengaged, either after the charge port has attempted to engage the latch or when the latch is already expected to be engaged.

Clear condition

The charge port (CP) latch engages, or the cable is unplugged from the charge port.

Signals to check

Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.

Signal	Unit
CP Aps Voltage `CP_a054_CP_apsVoltage`	V
Latch Counts Filtered `CP_a054_latchCountsFiltered`	%

Signal	Unit
CHG Insert Enable `CP_a054_CHG_InsertEnable`	—
CP Latch Enable Cmd `CP_a054_CP_latchEnableCmd`	—
CP Proximity `CP_a054_CP_proximity` 0 SNA 1 DISCONNECTED 2 UNLATCHED 3 LATCHED	—
Inlet ID `CP_a054_inletID` 0 SAE 1 IEC 2 GBAC 3 GBDC 4 MCS	—
Latch State `CP_a054_latchState` 0 SNA 1 DISENGAGED 2 ENGAGED 3 BLOCKING	—

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of CP_a054.