VCBATT1_a510 — LV Battery Recovery Timeout
Full alert identifier: VCBATT1_a510_LVBatteryRecoveryTimeout
Message shown in the car
LV Battery recovery attempt timed out Remove external power supplies and reconnect battery
Alert description
A low voltage (LV) battery recovery attempt has timed out and has been aborted, and the internal protection transistor (MOSFET) has been opened. May occur because an external power supply is connected to the LV battery, or due to a high impedance connection between the power conversion system (PCS) and LV battery. The low voltage battery management system (LVBMS) reports a FAULT state.
Potential impact
The high voltage (HV) system will remain energized to continue supplying electrical power to the vehicle while the LV battery is unavailable. This may result in greater range loss than expected, increased HV system energy consumption when the vehicle is idle, and prevent the vehicle from sleeping. The vehicle will be unable to drive while this alert persists.
Set condition
The LVBMS reports an LV battery recovery attempt has timed out and has been aborted because 50 seconds have passed without the LVBMS detecting adequate current flow to the LV battery across the internal protection transistor (MOSFET).
Clear condition
Will clear on next LV battery recovery attempt. To trigger another recovery attempt: disconnect then reconnect the LV battery, run the LV battery recovery ODIN routine, or cycle vehicle LV power. Be sure to remove / disconnect any external power supply before attempting to recover the LV battery.
Signals to check
Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.
| Signal | Unit |
|---|---|
Pack Voltage
VCBATT1_
|
V |
Sum Cell Voltage
VCBATT1_
|
V |
Target PCS Voltage
VCBATT1_
|
V |
| Signal | Unit |
|---|---|
Frunk Open
VCBATT1_
|
— |
Service Mode
VCBATT1_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of VCBATT1_a510.