RADC_a032 — Sensor Blocked

Full alert identifier: RADC_a032_sensorBlocked

Alert description

The radar sensor is blocked, possibly due to environmental factors such as snow, ice, or dirt. There may also be something causing interference between the radar and the secondary surface (fascia), such as the harness being in front of the radar.

Potential impact

Radar functions are disabled and Autopilot features will be disabled.

Set condition

The radar has detected a blockage of its sensor / antenna.

Clear condition

The radar sensor is cleared of any blockage.

Signals to check

These diagnostic fields are associated with RADC_a032. Check the alert's Alert Log in Service Mode Plus for available values.

Signal	Unit
Block SPM Blockage State `RADC_a032_block_SPMBlockageState` 0 DB NO DAMP 1 GDB INC DAMP 2 GDB FULL DAMP 3 GDB RDC DAMP 4 GDB UNKNOWN DAMP	—
Block SPM Self Test State `RADC_a032_block_SPMSelfTestState` 0 OFF 1 ON 2 STARTUP 3 ROADBEAM TEST	—
Block Dummy `RADC_a032_block_dummy`	—
Block Uc Esti Range `RADC_a032_block_ucEstiRange`	m
Block Uc Esti Range Conf `RADC_a032_block_ucEstiRangeConf`	—
Block Uc Esti Range Prob `RADC_a032_block_ucEstiRangeProb`	—
Block Uc Timeout Blk Conf `RADC_a032_block_ucTimeoutBlkConf`	—
Blockage Type `RADC_a032_blockageType` 0 ALN PATH COMP HIGH NEAR 1 FCTSEN INC BLOCKAGE 2 FCTSEN DEC BLOCKAGE 3 FCTSEN BLOCKAGE 4 FCTSEN OBJ NOT MEASURED	—

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of RADC_a032.