APP_w362 — Fascia Cam Init Fault

Full alert identifier: APP_w362_fasciaCamInitFault

Alert description

When the Autopilot electronic control unit (ECU) boots, the fascia camera is unable to initialize.

Autopilot features are not available

When the Autopilot ECU boots, communication cannot be established with the fascia camera.

Communication issue is rectified with the fascia camera, ECU is rebooted, and camera is initialized.

These diagnostic fields are associated with APP_w362. Check the alert's Alert Log in Service Mode Plus for available values.

Signal	Unit
Fascia Cam Deser Fault `APP_sw362_fasciaCamDeserFault` 0 NO I2C FAULT 1 I2C BUS FAULT 2 I2C SLAVE ADDR NACK 3 I2C DATA NACK 4 I2C UNKNOWN IOCTL ERR	—
Fascia Cam I 2 Cbus Fault `APP_sw362_fasciaCamI2CbusFault`	—
Fascia Cam Sensor Fault `APP_sw362_fasciaCamSensorFault` 0 NO I2C FAULT 1 I2C BUS FAULT 2 I2C SLAVE ADDR NACK 3 I2C DATA NACK 4 I2C UNKNOWN IOCTL ERR	—
Fascia Cam Ser Fault `APP_sw362_fasciaCamSerFault` 0 NO I2C FAULT 1 I2C BUS FAULT 2 I2C SLAVE ADDR NACK 3 I2C DATA NACK 4 I2C UNKNOWN IOCTL ERR	—

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of APP_w362.