Find the procedure. Understand what it does.
Explore diagnostic tests and repair tasks you can run with Tesware on compatible vehicles.
1,357
service tasks
Model 3, Y, S & X
857 tasks Showing 841–857
Clear filtersTests for power and connection of the rear left wheel speed sensor controlled by Electronic Stability Program (ESP).
TEST-ESP_REAR-L-WHEEL-SENSOR
Tests connection of wheel-end accelerometers to the Tesla Air Suspension (TAS) Electronic Control Unit (ECU).
TEST-SELF_TAS_X_ACCELS-CONNECTION
Checks the current Wi-Fi connection status.
PING-BASH_WIFI-STATUS
Calibrates all window endstops and pinch detection. Before running the routine, ensure all doors are closed. After starting the routine, do not open any door or press any window switch button.
PROC_VC_X_CALIBRATE-WINDOWS
Depending on the windshield installed, the Temperature Humidity Sensor (THS) will be configured different. Run this routine after replacing the windshield and select the windshield part number to ensure nominal HVAC performance.
PROC_VCRIGHT_X_WINDSHIELD-REPLACEMENT
Tests for power, connection, and communication of the windshield heater controlled by the Front Battery Controller (VCBATT2).
TEST-SELF_VCBATT2_X_AP-HEATER
Tests the power, connection, and communication of the windshield heater controlled by the Front Vehicle Controller (VCFRONT).
TEST-SELF_VCFRONT_X_AP-HEATER
Passes if low fluid level is detected. Fails if switch is disconnected or fluid level is not low.
TEST-SELF_VCBATT2_X_WASHER-FLUID-LEVEL-SWITCH
Passes if low fluid level is detected. Fails if switch is disconnected or fluid level is not low.
TEST-SELF_VCFRONT_X_WASHER-FLUID-LEVEL-SWITCH
Tests the electrical connection between with the windshield washer fluid pump and the level switch controlled by the Front Vehicle Controller (VCFRONT).
TEST-SELF_VCFRONT_X_WASHER
Passes if the windshield washer fluid pump is connected. Fails if no load is detected.
TEST-SELF_VCBATT2_X_WASHPUMP
Passes if the windshield washer fluid pump is connected. Fails if no load is detected.
TEST-SELF_VCFRONT_X_WASHPUMP
Tests for power, connection, and communication of the wiper heater controlled by the Front Battery Controller (VCBATT2).
TEST-SELF_VCBATT2_X_WIPER-HEATER
Tests for power, connection, and communication of the wiper heater controlled by the Front Vehicle Controller (VCFRONT).
TEST-SELF_VCFRONT_X_WIPER-HEATER
After a windshield wiper module replacement, this routine runs all required tasks.
PROC_WIPER_X_POST-REPLACEMENT-PROCEDURES
Tests the wireless charger for power and connection. When communication and connection are established, the test will succeed. If the test fails, inspect wiring and make sure the wireless charger is powered.
PING-BASH_WIRELESS-CHARGER
This routine allows one to write or read the BMB ASIC type to the HVBMS and HVP ECUs. See Toolbox Article 7761700 for more details regarding how to determine the correct BMB ASIC type to write, if needed.
PROC_HVC_X_BMB-ASIC-TYPE