ModelX/tasks/PROC_BCCEN_X_PROVISIONING
Provision BCCEN by learning the vehicle vin. Once provisioned, keyfobs will need to be re-paired. If using a keyfob that was previously connected to a vehicle, first use the toolbox3 keyfob pairing tool to unpair and clear personalization.
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
Once provisioned, the BCCEN will require a signed command to unprovision.
No user inputs are listed in this firmware.
Tests communication with the Body Controller (BCCEN) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
PING-TP_BCCEN
This test calibrates the steering column. When the calibration is run, the steering column will first move all the way in, then move out to the endpoint. Next, the up/down axis will be calibrated in the same manner. The calibration routine is used to set the zero position of both axes and to determine the number of motor encoder counts it takes to reach the other end point of the column's travel.
PROC_BCCEN_X_CALIBRATE-STEERING-COLUMN
This routine is used to reset the drive unit immobilizer key. This re-learns the code that pairs the drive unit with the security controller (BCCEN). This routine needs to be performed when either the security controller is replaced or the drive unit is permanently removed from a vehicle.
PROC_BCCEN_X_IMMOBILIZER-RESET
This routine runs on the central body controller (BCCEN) and verifies that the Intrusion Tilt Sensor and Battery Backed Siren have been installed and are functioning correctly.
TEST_BCCEN_X_INTRUSION-DETECTION