Skip to content
Service procedures 2026 firmware

Continental Service Drive Alignment

ModelSX/tasks/PROC_RADC_X_CONTINENTAL-SERVICE-DRIVE-ALIGNMENT

Model S / X (legacy)

What this task does

This routine will perform a Service Drive Alignment for Continental Radars to check vertical calibration. Before starting the routine, make sure Gateway is unlocked and Drive-rail is turned on. Follow on screen instructions.

Vehicle & firmware coverage

Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.

Model S / X (legacy) Legacy infotainment · Firmware 2026.14.6
Vehicle coverage
Pre-2021 Model S, Pre-2021 Model X
Supported connection
Local connection
Vehicle state
Stationary · Parked; Stationary · Drive; Moving · Drive
Gateway diagnostic level
Service, ServiceDrive, Factory

Procedure notes

Alerts regarding Driver Assist Features unavailable may be presents. Will be cleared when calibration is completed.

Task inputs (0)

No user inputs are listed in this firmware.

Related service tasks

Browse all tasks →
Service procedures

BOSCH Radar Service Drive Alignment

This Routine is checking the calibration of the BOSCH Forward Facing Radar. The vehicle needs to be driven on a straight road with a minimum speed of 30mph/50kph. The progress bar will show current progress and will update depending on the road/drive conditions. Reasons for not updating are: Speed might be too low/high or the steering wheel is not straight enough. When the vehicle is put into park when the routine is not completed, this will ABORT the routine.

PROC_RADC_X_BOSCH-SERVICE-DRIVE-ALIGNMENT

Model S / X (legacy)