ModelSX/tasks/PING-TP_ESP
Tests communication with the Electronic Stability Program (ESP) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
No user inputs are listed in this firmware.
Routine will follow these steps to configure the ESP: 1. Record Part Number 2. Record Serial Number 3. Learn vehicle VIN 4. Calibrate yaw rate (Ax) sensor 5. Configure Vehicle performance config
PROC_ESP_X_ESP-CONFIG
The Electronic Stability Program (ESP) Hydraulic Control Unit executes the brake fluid flush and bleed process. Active-circuit wheels are Front-Left (FL) and Rear-Right (RR). Use this routine only during fluid flush or bleed with appropriate brake bleeding equipment. The estimated time to complete is five seconds. The ESP Hydraulic Control Unit will run the high pressure pump and control circuit valves to facilitate a prescheduled brake fluid flush or bleed.
PROC_ESP_FRONT-L-REAR-R_BRAKE-BLEED
The Electronic Stability Program (ESP) Hydraulic Control Unit executes the brake fluid flush and bleed process. Active-circuit wheels are Front-Right (FR) and Rear-Left (RL). Use this routine only during fluid flush or bleed with appropriate brake bleeding equipment. The estimated time to complete is five seconds. The ESP Hydraulic Control Unit will run the high pressure pump and control circuit valves to facilitate a prescheduled brake fluid flush or bleed.
PROC_ESP_FRONT-R-REAR-L_BRAKE-BLEED