ModelS/tasks/PROC_DI_X_IMMOBILIZER-RESET
This routine can be used to reset the drive unit immobilizer to the virgin state. This unlearns the code that pairs a drive unit to the security controller. This routine needs to be performed when either the security controller is replaced or the drive unit is permanently removed from a vehicle. Immobilizer reset takes 15 minutes. During this time, DI_immobilizerState will be in RESET, and at the end of the procedure it will become DISARMED. Drive rail must remain on throughout the entire procedure. When the immobilizer reads "Disarmed", the drive unit can be paired with the security controller the next time it is powered on.
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
ProcedureTimeoutSeconds · Int
Firmware default: 900
ResultsPollInterval · Int
Firmware default: 5
Tests communication with the Drive Inverter (DI) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
PING-TP_DI
Send a hard reset ECU command to the DI
TEST-RESET_DI