Skip to content
Self-tests 2026 firmware

Right Side Repeater Connectivity Self-Test

Gen3/tasks/TEST-SELF_VCFRONT_R_SIDE-REPEATER

What this task does

Tests the connectivity of the right side repeater.

Vehicle & firmware coverage

Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.

Model 3 / Y AMD · Firmware 2026.32.3
Vehicle coverage
2024+ Model 3, 2025+ Model Y, Model Y, Pre-2024 Model 3
Supported connection
Local connection
Vehicle state
Stationary · Drive; Stationary · Neutral; Stationary · Parked; Stationary · Reverse
Gateway diagnostic level
No specific level listed

Procedure notes

The right side repeater lights and camera will turn on and off briefly.

Task inputs (0)

No user inputs are listed in this firmware.

Model 3 / Y Intel · Firmware 2026.32.7
Vehicle coverage
Model Y, Pre-2024 Model 3
Supported connection
Local connection
Vehicle state
Stationary · Drive; Stationary · Neutral; Stationary · Parked; Stationary · Reverse
Gateway diagnostic level
No specific level listed

Procedure notes

The right side repeater lights and camera will turn on and off briefly.

Task inputs (0)

No user inputs are listed in this firmware.

Model S / X (2021+) AMD · Firmware 2026.20.6.1
Vehicle coverage
2021+ Model S, 2021+ Model X
Supported connection
Local connection
Vehicle state
Stationary · Drive; Stationary · Neutral; Stationary · Parked; Stationary · Reverse
Gateway diagnostic level
No specific level listed

Procedure notes

The right side repeater lights and camera will turn on and off briefly.

Task inputs (0)

No user inputs are listed in this firmware.

Browse all tasks →
Service procedures

12V Reset

Power cycles all of the eFuses on the Vehicle Front Controller (VCFRONT) and shuts off Sleep Bypass.

PROC_VCFRONT_X_12V-RESET

Model 3 / Y
Self-tests

Active Louver Self Test

Performs louver connection check. Will only move the louver through partial range of motion.

TEST-SELF_VCFRONT_X_ACTIVE-LOUVER

Model 3 / Y
Service procedures

Allow High Beam Enablement in Factory Mode

Allows high beams to be enabled in Factory Mode until the Front Vehicle Controller (VCFRONT) ECU is power cycled.

PROC_VCFRONT_X_ALLOW-HIGH-BEAMS-FACTORY

Model S / X (2021+)
Self-tests

Ambient Sensor Test

Tests for power, connection, and communication of the ambient sensor controlled by the Front Vehicle Controller (VCFRONT).

TEST-SELF_VCFRONT_X_AMBIENT-TEMP

Model 3 / Y Model S / X (2021+)