Communication checks
Drive Interface CAN Communication
Tests Controller Area Network (CAN) communication with the pedal monitor (PM).
PING-TP_PM
Model S / X (2021+)
ECU resets
2026 firmware
Pedal Monitor master (PM) node UDS ECU Reset
Gen3/tasks/TEST-RESET_PM
What this task does
Resets Pedal Monitor master (PM) Electronic Control Unit (ECU). Reset is executed via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
Vehicle & firmware coverage
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
Model 3 / Y AMD · Firmware 2026.32.3
- Vehicle coverage
- 2024+ Model 3, 2025+ Model Y, Model Y, Pre-2024 Model 3
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- Service, Factory, DiagLinkActive
Task inputs (0)
No user inputs are listed in this firmware.
Model 3 / Y Intel · Firmware 2026.32.7
- Vehicle coverage
- Model Y, Pre-2024 Model 3
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- Service, Factory, DiagLinkActive
Task inputs (0)
No user inputs are listed in this firmware.
Model S / X (2021+) AMD · Firmware 2026.20.6.1
- Vehicle coverage
- 2021+ Model S, 2021+ Model X
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- Service, Factory, DiagLinkActive
Task inputs (0)
No user inputs are listed in this firmware.
Related service tasks
Browse all tasks →
Communication checks
Pedal Monitor CAN Communication
Tests communication with the Pedal Monitor (PM) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
PING-TP_PM
Model 3 / Y