Gen3/tasks/PROC_ESP_X_CLEAR-DTCS
Clears Diagnostic Trouble Codes (DTC) in the Electronic Stability Program (ESP) Electronic Control Unit (ECU).
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
No user inputs are listed in this firmware.
No user inputs are listed in this firmware.
No user inputs are listed in this firmware.
Tests the communication of the Electronic Stability Program (ESP) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the chassis Controller Area Network (CAN).
PING-TP_ESP
Tests the communication of the Electronic Stability Program (ESP) Electronic Control Unit (ECU). Communication is established over the Party Controller Area Network (CAN).
PING-DTC_ESP_X_PARTY
Resets the Electronic Stability Program (ESP) Electronic Control Unit (ECU). Reset is executed via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
TEST-RESET_ESP
The Electronic Stability Program (ESP) Hydraulic Control Unit executes the brake fluid flush and bleed process. Active-circuit wheels are Front-Left (FL) and Rear-Right (RR). Use this routine only during fluid flush or bleed with appropriate brake bleeding equipment. The estimated time to complete is five seconds. The ESP Hydraulic Control Unit will run the high pressure pump and control circuit valves to facilitate a prescheduled brake fluid flush or bleed.
PROC_ESP_FRONT-L-REAR-R-BRAKE-BLEED