Oil Pump Fill Control

Gen3/tasks/PROC_DIX_X_OIL-PUMP-FILL-CONTROL

Model 3 / Y

What this task does

Actuates the drive unit oil pump to circulate oil while filling the selected drive unit. The pump runs at 5 LPM for 10 minutes Press STOP at any time to end the routine early.

Vehicle & firmware coverage

Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.

Model 3 / Y AMD · Firmware 2026.32.3

Vehicle coverage: 2024+ Model 3, 2025+ Model Y
Supported connection: Local connection and remote access
Vehicle state: Stationary · Parked; Stationary · Neutral
Gateway diagnostic level: Service, DiagLinkActive, Factory

Procedure notes

Oil pump will run on the selected drive unit.

Task inputs (1)

Drive Unit

base_name · EnumType

Drive unit to run the oil pump on during fill

Firmware default: Front

Options: Front, Rear