End EPBL Service Mode
Ends service mode on the left EPB
PROC_EPBL_STOP-SERVICE-MODE
Gen3/tasks/PING-TP_EPBL
Tests the communication of the Left Electronic Parking Brake (EPBL) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
When communication is established, the test will succeed. If the test fails, inspect wiring and ensure ECU is powered.
No user inputs are listed in this firmware.
When communication is established, the test will succeed. If the test fails, inspect wiring and ensure ECU is powered.
No user inputs are listed in this firmware.
When communication is established, the test will succeed. If the test fails, inspect wiring and ensure ECU is powered.
No user inputs are listed in this firmware.
Ends service mode on the left EPB
PROC_EPBL_STOP-SERVICE-MODE
Resets the Left Electronic Parking Brake (EPBL) Electronic Control Unit (ECU). Reset is executed via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
TEST-RESET_EPBL
Tests current of the front left seat controlled by the Left Electronic Parking Brake (EPBL) Electronic Control Unit (ECU).
TEST-SELF_EPBL_FRONT_SEAT-FAN
Clears current EPBL config and learns new config from gtw car configs. Only use after replacing EPB hardware where gtw config change was required.
PROC_EPBL_CLEAR-BRAKE-HW-TYPE