Common/tasks/PROC_TAS_X_ASSISTED-INFLATE
The procedure assists the inflation of a component on a Tesla Air Suspension (TAS) vehicle.
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
To run the procedure, a nitrogen tank with pressure set to 8 bar(a) / 116 psi(a) must be connected to inflate springs. A nitrogen tank with pressure set to 20 bar(a) / 290 psi(a) must be connected to inflate the reservoir. While running, the air suspension might physically move.
ActionTarget · String
Targeted Component
Firmware default: FL
Options: FL, FR, RL, RR, FRONT_AXLE, REAR_AXLE, RESERVOIR, SPRINGS
To run the procedure, a nitrogen tank with pressure set to 8 bar(a) / 116 psi(a) must be connected to inflate springs. A nitrogen tank with pressure set to 20 bar(a) / 290 psi(a) must be connected to inflate the reservoir. While running, the air suspension might physically move.
ActionTarget · String
Targeted Component
Firmware default: FL
Options: FL, FR, RL, RR, FRONT_AXLE, REAR_AXLE, RESERVOIR, SPRINGS
Tests communication with the Air Suspension Chassis (TAS) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
PING-TP_TAS
Measures the air pressure of the Tesla Air Suspension (TAS) system.
PROC_TAS_X_MEASURE-AIR-SUSPENSION-PRESSURE
Calibrate the ride height of the Tesla Air Suspension (TAS).
PROC_TAS_X_CALIBRATE-RIDE-HEIGHT-PACK
Check Tesla Air Suspension (TAS) Electronic Control Unit (ECU) mode.
PROC_TAS_X_CHECK-RUN-MODE