Service procedures
Disarm RCM
Disarms the Restraints Control Module (RCM)
PROC_RCM_DISARM
Model 3 / Y
Model S / X (2021+)
Service procedures
2026 firmware
Safety System Continuous Resistance Check
Common/tasks/PROC_RCM_X_DEPLOYMENT-LOOP-CONTINUOUS-MONITOR
What this task does
Returns the resistances of the deployment loops controlled by the Restraints Control Module (RCM).
Vehicle & firmware coverage
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
Model 3 / Y AMD · Firmware 2026.32.3
- Vehicle coverage
- 2024+ Model 3, 2025+ Model Y, Model Y, Pre-2024 Model 3
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- DiagLinkActive, Factory, Service
Procedure notes
Before performing any Supplementary Restraint System (SRS) related repairs, RCM must be disarmed, be sure to run PROC_RCM_DISARM routine. Vehicle airbags can deploy if the vehicle's RCM is armed and disturbed while LV power is connected.
Task inputs (1)
Duration
duration_minutes · Int
Monitor time (1–30 min)
Firmware default: 5
Model 3 / Y Intel · Firmware 2026.32.7
- Vehicle coverage
- Model Y, Pre-2024 Model 3
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- DiagLinkActive, Factory, Service
Procedure notes
Before performing any Supplementary Restraint System (SRS) related repairs, RCM must be disarmed, be sure to run PROC_RCM_DISARM routine. Vehicle airbags can deploy if the vehicle's RCM is armed and disturbed while LV power is connected.
Task inputs (1)
Duration
duration_minutes · Int
Monitor time (1–30 min)
Firmware default: 5
Model S / X (2021+) AMD · Firmware 2026.20.6.1
- Vehicle coverage
- 2021+ Model S, 2021+ Model X
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- DiagLinkActive, Factory, Service
Procedure notes
Before performing any Supplementary Restraint System (SRS) related repairs, RCM must be disarmed, be sure to run PROC_RCM_DISARM routine. Vehicle airbags can deploy if the vehicle's RCM is armed and disturbed while LV power is connected.
Task inputs (1)
Duration
duration_minutes · Int
Monitor time (1–30 min)
Firmware default: 5
Related service tasks
Browse all tasks →
Diagnostic tests
Driver Front Airbag, 1st Stage Connection
Tests the connection of the driver airbag to the Restraints Control Module (RCM) Electronic Control Unit (ECU).
TEST-PYRO_RCM_X_DAB-STAGE-1
Model 3 / Y
Diagnostic tests
Driver Front Airbag, 2nd Stage Connection
Tests the connection of the driver airbag to the Restraints Control Module (RCM) Electronic Control Unit (ECU).
TEST-PYRO_RCM_X_DAB-STAGE-2
Model 3 / Y
Service procedures
RCM - Learn WVTA
Restraint Control Module (RCM) learns the Whole Vehicle Type Approval (WVTA) string mapping via Gateway (GTW) configurations.
PROC_RCM_X_LEARN-WVTA-FROM-CONFIGS
Model 3 / Y
Model S / X (2021+)