Common/tasks/PROC_ICE_X_FORCE-INSTALL-UPDATE
The force install update procedure immediately runs a staged firmware update on the vehicle.
Open a version to see its description, requirements, and input definitions. Hardware configuration and live vehicle checks also determine availability.
Touchscreen will appear blank and the vehicle will be unable to drive until the update is complete. The procedure should only be run if User Interface (UI) or MobileApp connectivity is unavailable.
No user inputs are listed in this firmware.
Touchscreen will appear blank and the vehicle will be unable to drive until the update is complete. The procedure should only be run if User Interface (UI) or MobileApp connectivity is unavailable.
No user inputs are listed in this firmware.
Touchscreen will appear blank and the vehicle will be unable to drive until the update is complete. The procedure should only be run if User Interface (UI) or MobileApp connectivity is unavailable.
No user inputs are listed in this firmware.
Touchscreen will appear blank and the vehicle will be unable to drive until the update is complete. The procedure should only be run if User Interface (UI) or MobileApp connectivity is unavailable.
No user inputs are listed in this firmware.
Deletes the cached Autopilot Electronic Control Unit (ECU) (APE) image from the Infotainment and Connectivity ECU (ICE) to force a new download during the next update.
PROC_ICE_X_CLEAR-APE-CACHE
Creates and uploads an encrypted user profile data backup. The vehicle must have connectivity. Depending on the size of the backup and the network signal strength, the process can take between 30 seconds and 3 minutes.
PROC_ICE_X_PROFILE-BACKUP
Returns the calibration progress and status for each camera. This task fails if any camera is uncalibrated.
PROC_ICE_X_CAMERA-CALIBRATION-STATUS
Send a keep-awake request to the gateway for 15 minutes
PROC_ICE_X_KEEP-AWAKE