VCLEFT_a205 — Epbm Over I Dyn
Full alert identifier: VCLEFT_a205_epbmOverIDyn
Alert description
Electronic Parking Brake Monitor measured more current than is required for Electronic Parking Brake to remain in DYNAMIC_APPLYING.
Potential impact
The caliper may have a higher than expected braking force.
Set condition
Electronic Parking Brake attempted to remain in DYNAMIC_APPLYING while Electronic Parking Brake Monitor had measured more than the maximum current allowed to remain in DYNAMIC_APPLYING.
Clear condition
A new Electronic Parking Brake operation starts.
Signals to check
Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.
| Signal | Unit |
|---|---|
Current
VCLEFT_
|
A |
| Signal | Unit |
|---|---|
Desync Count
VCLEFT_
|
— |
Dyn Apply Allowed
VCLEFT_
|
— |
Dynamic Allowed
VCLEFT_
|
— |
Epb Config
VCLEFT_
|
— |
Open Allowed
VCLEFT_
|
— |
Park Allowed
VCLEFT_
|
— |
Park Pending Allowed
VCLEFT_
|
— |
Parking Allowed
VCLEFT_
|
— |
Show 7 more fields
| Signal | Unit |
|---|---|
Release Allowed
VCLEFT_
|
— |
Service Allowed
VCLEFT_
|
— |
Start Allowed
VCLEFT_
|
— |
Unknown Allowed
VCLEFT_
|
— |
Wench Pending Allowed
VCLEFT_
|
— |
Winch Allowed
VCLEFT_
|
— |
Winch Release Allowed
VCLEFT_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of VCLEFT_a205.