VCBATT_a188 — Sleep Failed
Full alert identifier: VCBATT_a188_sleepFailed
Alert description
The vehicle controller was not able to go to sleep.
Potential impact
Higher SoC loss than expected, higher 12V draw than expected, possible unexpected alerts.
Set condition
The vehicle controller started sleep sequence but was aborted.
Clear condition
The vehicle controller is able to successfully sleep.
Signals to check
Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.
| Signal | Unit |
|---|---|
IBS Current
VCBATT_
|
A |
Sleep Bypass Current
VCBATT_
|
A |
Time Not Sleeping
VCBATT_
|
sec |
| Signal | Unit |
|---|---|
CAN After Quiet
VCBATT_
|
— |
LV Support
VCBATT_
|
— |
Frunk Open
VCBATT_
|
— |
Service Mode
VCBATT_
|
— |
Vehicle State
VCBATT_
|
— |
Wake Up Bus ID
VCBATT_
|
— |
Wake Up Msg ID
VCBATT_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of VCBATT_a188.