PARK_a066 — Calibration Missing

Full alert identifier: PARK_a066_calibrationMissing

Alert description

The calibration block in D-Flash is missing or not available

Potential impact

The default calibration is used.

Set condition

On boot, the calibration block cannot be read.

Clear condition

Requires a 12v reset and the fault condition to be cleared

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of PARK_a066.

PARK_a002 — S1 internal Fail PARK_a002_s1_internalFail Sensor internal failure occured - like sensor damping resistor error or broken or disconnected membrane error, self diagnosis error or sensor reset or sensor resonator drift
PARK_a003 — S1 lin Comm Error PARK_a003_s1_linCommError This error is detected by the ECU. Sensor short to GND or short to plus or broken sensor line and all LIN errors
PARK_a007 — S2 internal Fail PARK_a007_s2_internalFail Sensor internal failure occured - like sensor damping resistor error or broken or disconnected membrane error, self diagnosis error or sensor reset or sensor resonator drift
PARK_a008 — S2 lin Comm Error PARK_a008_s2_linCommError This error is detected by the ECU. Sensor short to GND or short to plus or broken sensor line and all LIN errors
PARK_a012 — S3 internal Fail PARK_a012_s3_internalFail Sensor internal failure occured - like sensor damping resistor error or broken or disconnected membrane error, self diagnosis error or sensor reset or sensor resonator drift

Browse all PARK alert codes