GTW_w053 — Bus Sleep Failure

Full alert identifier: GTW_w053_busSleepFailure

Alert description

Bus failed to sleep when commanded

Potential impact

This information is not available in the alert reference.

Set condition

This information is not available in the alert reference.

Clear condition

This information is not available in the alert reference.

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of GTW_w053.

GTW_w061 — Bmp Sleep Failure GTW_w061_bmpSleepFailure BMP was power cycled due to failure to sleep after 60 seconds.
GTW_w072 — Update Failure GTW_w072_updateFailure The vehicle gateway (GTW) detects that at least one electronic control unit (ECU) did not successfully install an update during an attempted vehicle software update. Version mismatch alerts should be present indicating any ECUs affected as…
GTW_w057 — I2C Failure GTW_w057_i2cFailure I2C bus failed. I2C will be reset
GTW_w058 — Rtc Alarm Failure GTW_w058_rtcAlarmFailure Setting of RTC alarm failed. GTW will remain awake
GTW_w050 — Sd Card Init Failure GTW_w050_sdCardInitFailure The vehicle gateway (GTW) cannot initialize its microSD card, which may indicate the microSD card is not installed correctly or needs to be replaced.

Browse all GTW alert codes