DI_a168 — Proximity Drive Denial

Full alert identifier: DI_a168_proximityDriveDenial

Message shown in the car

Charge cable connected to vehicle Disconnect charge cable to drive

Alert description

The reported proximity voltage indicates that there is a charge cable connected to the vehicle while the vehicle is in a drive state (Drive or Reverse).

Potential impact

This alert is for diagnostic logging purposes only.

Set condition

The vehicle is in a drive state and proximity voltage indicates that a charge cable is connected to the vehicle.

Clear condition

There is no longer proximity voltage indicating a charge cable.

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of DI_a168.

DI_a085 — Proximity In Enable DI_a085_proximityInEnable The charge port (CP) electronic control unit (ECU) reports proximity voltage that indicates that there is a charge cable connected to the vehicle.
DI_a137 — No Capable Drive Units DI_a137_noCapableDriveUnits The drive interface (DI) electronic control unit (ECU) detects that none of the vehicle's drive units are capable of producing torque.
DI_a171 — Drive Rail Not Requested DI_a171_driveRailNotRequested The drive interface (DI) electronic control unit (ECU) cannot confirm that a vehicle controller ECU requested a drive state, and as a result blocks shifting into Drive or Reverse.
DI_a174 — Not Ok To Start Drive DI_a174_notOkToStartDrive The drive interface (DI) electronic control unit (ECU) detects that the low voltage (LV) supply is too low to shift into Drive.
DI_a143 — Mcu Limit Active DI_a143_mcuLimitActive The media control unit (MCU) is limiting the top speed and power of the drive unit(s).

Browse all DI alert codes