DI_a144 — Config Mismatch
Full alert identifier: DI_a144_configMismatch
Alert description
The drive interface (DI) or drive inverter (DIx) electronic control unit (ECU) detects a Gateway configuration mismatch with the application currently running on the DI.
Potential impact
The vehicle enters system limp mode and is unable to enter Drive.
Set condition
Set if any of the checked gateway config is not as expected.
Clear condition
Clears when all of the checked gateway configurations are as expected.
Signals to check
These diagnostic fields are associated with DI_a144. Check the alert's Payload in Service Mode Plus for available values.
| Signal | Unit |
|---|---|
Autonomy Feature Type
DI_
|
— |
Autopilot
DI_
|
— |
Brake Actuation Type
DI_
|
— |
Brake HW Type
DI_
|
— |
Cabin PTC Heater Type
DI_
|
— |
Chassis Sub Type
DI_
|
— |
Chassis Type
DI_
|
— |
Das Hw
DI_
|
— |
Show 13 more fields
| Signal | Unit |
|---|---|
Drivetrain Type
DI_
|
— |
Frunk Latch Type
DI_
|
— |
Heatsink Type
DI_
|
— |
Inverter Hardware
DI_
|
— |
Oil Pump 1 Hw Type
DI_
|
— |
Oil Pump 2 Hw Type
DI_
|
— |
Pack Energy
DI_
|
— |
Pack Performance Deviation
DI_
|
— |
Performance Package
DI_
|
— |
Platform Max Bus Voltage
DI_
|
— |
Power Liftgate Type
DI_
|
— |
Soft Performance Limit
DI_
|
— |
Vdc Type
DI_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of DI_a144.