DIR_a011 — Sw Power Stage Not Ready

Full alert identifier: DIR_a011_swPowerStageNotReady

Alert description

The Drive Inverter (DIx) power stage is not ready. There may be a condition affecting the DIx control board.

DIx may not function as expected.

The DIx power stage is not ready. One of the pre-drive gate driver checks has failed. There may be a condition affecting the DIx control board.

The DIx power stage is ready and functions as expected.

These diagnostic fields are associated with DIR_a011. Check the alert's Payload in Service Mode Plus for available values.

Signal	Unit
Bad Data Expected `DIR_a011_badDataExpected`	—
Bad Data Read `DIR_a011_badDataRead`	—
Bad Gate Drive IC `DIR_a011_badGateDriveIC`	—
Code Branch `DIR_a011_codeBranch`	—
Phase A High `DIR_a011_phaseAHigh`	—
Phase A Low `DIR_a011_phaseALow`	—
Phase B High `DIR_a011_phaseBHigh`	—
Phase B Low `DIR_a011_phaseBLow`	—

Show 4 more fields

Signal	Unit
Phase C High `DIR_a011_phaseCHigh`	—
Phase C Low `DIR_a011_phaseCLow`	—
Reason `DIR_a011_reason` 0 GATE DRIVE SUPPLY 1 REG DATA MISMATCH 2 CRC MISMATCH 3 FAULT DURING CONFIG 4 SPI ERROR	—
Reg Address `DIR_a011_regAddress`	—

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of DIR_a011.